enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. T-slot structural framing - Wikipedia

   en.wikipedia.org/wiki/T-slot_structural_framing

   Cross-section of 80/20 T-slotted profiles, 10 and 15 series A bicycle trailer for bike-trekking with three Euroboxes and aluminium profile framing T-slot structural framing is a framing system consisting of lengths of square or rectangular extruded aluminium, typically 6105-T5 aluminium alloy , with a T-slot down the centerline of one or more ...

3. Semi-finished casting products - Wikipedia

   en.wikipedia.org/wiki/Semi-finished_casting_products

   Final products include bar stock and wire. [3] Centrifugal casting is also used to produce short circular tubes as billets, usually to achieve a precise metallurgical structure. They are commonly used as cylinder sleeves where the inner and outer diameters are ground and machined to length. Because their size is not modified significantly, they ...

4. Extrusion - Wikipedia

   en.wikipedia.org/wiki/Extrusion

   Aluminium is the most commonly extruded material. Aluminium can be hot or cold extruded. If it is hot extruded it is heated to 575 to 1100 °F (300 to 600 °C). Examples of products include profiles for tracks, frames, rails, mullions, and heat sinks. Brass is used to extrude corrosion free rods, automobile parts, pipe fittings, engineering parts.

5. 2218 aluminium alloy - Wikipedia

   en.wikipedia.org/wiki/2218_aluminium_alloy

   2218 aluminium alloy is an alloy in the wrought aluminium-copper family (2000 or 2xxx series). It is one of the most complex grades in the 2000 series, with at least 88.4% aluminium by weight. Unlike most other aluminium-copper alloys, 2218 is a high work-ability alloy, with relatively low for 2xxx series alloy yield strength of 255 MPa.

6. Rolling (metalworking) - Wikipedia

   en.wikipedia.org/wiki/Rolling_(metalworking)

   The output from a strip mill is coiled and, subsequently, used as the feed for a cold rolling mill or used directly by fabricators. Billets, for re-rolling, are subsequently rolled in either a merchant, bar or rod mill. Merchant or bar mills produce a variety of shaped products such as angles, channels, beams, rounds (long or coiled) and hexagons.

7. Bimetal - Wikipedia

   en.wikipedia.org/wiki/Bimetal

   A common type of trimetallic object (before the all-aluminium can) was a tin-plated steel can with an aluminum lid with a pull tab. Making the lid out of aluminum allowed it to be pulled off by hand instead of using a can opener, but these cans proved difficult to recycle owing to their mix of metals.