Search results
Results from the WOW.Com Content Network
Intel reacted to the problem by shipping ICH5 with increased ESD tolerance. Effective ESD preventive measures on USB ports are difficult and costly, since they can impair the quality of the USB-2.0 high-speed signals. Many motherboard manufacturers had omitted the necessary high-quality safety devices for front panel connectors for cost reasons.
USB Battery Charging (BC) defines a charging port, which may be a charging downstream port (CDP), with data, or a dedicated charging port (DCP), without data. Dedicated charging ports can be found on USB power adapters to run attached devices and battery packs. Charging ports on a host with both kinds will be labeled. [59]
Standard USB hub ports can provide from the typical 500 mA/2.5 W of current, only 100 mA from non-hub ports. USB 3.0 and USB On-The-Go supply 1.8 A/9.0 W (for dedicated battery charging, 1.5 A/7.5 W full bandwidth or 900 mA/4.5 W high bandwidth), while FireWire can in theory supply up to 60 watts of power, although 10 to 20 watts is more typical.
The southbridge typically implements the slower capabilities of the motherboard in a northbridge-southbridge chipset computer architecture. In systems with Intel chipsets, the southbridge has been named I/O Controller Hub (ICH) and later replaced by Platform Controller Hub chipsets. In older Intel/AMD architectures the southbridge is usually ...
The projected result was a 5–15% failure rate within three years of 3 Gbit/s SATA ports, commonly used for storage devices such as hard drives and optical drives. The bug was present in revision B2 of the chipsets, and was fixed with B3. Z68 did not have this bug, since the B2 revision for it was never released. 6 Gbit/s ports were not affected.
Today, few consumer-grade PC-compatible computers include COM ports, [3] though some of them do still include a COM header on the motherboard. [ 4 ] After the RS-232 COM port was removed from most consumer-grade computers, an external USB-to-UART serial adapter cable was used to compensate for the loss.
In computing, a legacy port is a computer port or connector that is considered by some to be fully or partially superseded. [1] The replacement ports usually provide most of the functionality of the legacy ports with higher speeds, more compact design, or plug and play and hot swap capabilities for greater ease of use.
It is concluded that motherboards with the Knoll Activator would be built with I/O from the processor and low-cost I/O chips. [19] Individual chipset models differ in the number of PCI Express lanes, USB ports, and SATA connectors, as well as supported technologies; the table below shows these differences. [20] [21]