Search results
Results from the WOW.Com Content Network
The 2.2l S10/Sonoma had the starter located in the same position as front wheel drive cars. A rear wheel drive bellhousing is displayed at right, and the integrated front wheel drive bellhousing is displayed at the lower right (in this case, as a part of the GM 6T70 Transmission). GM 60-Degree 2.8/3.1/3.4/3.5/3.9 L V6 (also used by AMC) Buick ...
The General Motors Automatic Safety Transmission (AST) was a semi-automatic transmission released in 1937. The first mass-produced fully-automatic transmission developed for passenger automobile use was the GM Hydra-Matic introduced in the autumn of 1939 as a (very likely subsidized) $57 option for the 1940 Oldsmobile. [1]
The original version of the transmission had a 27-spline input shaft (shared with the THM200C and 2004R) which was a common failure point. In 1984, the 700R4 designed for use behind Chevrolet small block V8s received a 30-spline input shaft similar to those found on TH400 transmissions and which also used a different torque converter than its 2 ...
Not only was the transmission shifting to a very much higher range ( 2.93 to 1.56, but it was also simultaneously emptying the fluid coupling and making a mechanical lock-up. The wide gap in the reduction ratio between first and second gears combined with the direct mechanical connection to the engine to create a shift that could be firm enough ...
The two transmissions cannot be differentiated from the outside. The 4L65E shares the same exterior parts but have stronger internals such as 5 pinion planets compared to 4 in the 4L60E. 4L60E uses a 6.5" depth bell with 6 bolts for non gen 3 LS applications and a 7" depth bell with 7 bolts for LS applications.
The Powerglide is a two-speed automatic transmission designed by General Motors.It was available primarily on Chevrolet from January 1950 [1] through 1973, although some Pontiac models also used this automatic transmission after the fire at the Hydra-Matic factory in 1953.
The basis of the Turboglide's unique abilities was its five-element torque converter.Most automatic transmissions have a three-element torque converter, consisting of an impeller (an engine-driven pump); a turbine that rotates with the flywheel; a transmission-driven turbine that receives the energy of the oil propelled by the impeller, and a stator that redirects the recirculating oil so that ...
This same transmission is used in the Saturn Vue Green Line hybrid vehicle with the addition of an auxiliary oil pump and hybrid-aware electronics. It is designed for 3.0–3.5 L engines producing up to 205 ft·lbf (278 N·m) of torque, but was also commonly mated to some versions of GM's 4-cylinder Ecotec line.