enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Fish tape - Wikipedia

   en.wikipedia.org/wiki/Fish_tape

   A fish tape (also called a draw wire, draw tape, or an electrician ' s snake) is a tool used by electricians to route new wiring through walls and electrical conduit. [1]Made of a narrow band of spring steel, by careful manipulation, the tape can be guided through confined spaces such as wall cavities or conduits in many countries.

3. Cable jetting - Wikipedia

   en.wikipedia.org/wiki/Cable_Jetting

   Jetting. Cable jetting is the process of blowing a cable through a duct while simultaneously pushing the cable into the duct. Compressed air is injected at the duct inlet and flows through the duct and along the cable at high speed. (Preferably, no suction pig is used at the cable head.) The high speed air propels the cable due to drag forces ...

4. Towing sock - Wikipedia

   en.wikipedia.org/wiki/Towing_sock

   A towing sock or wire rope puller or wire pulling grip is a device that connects to the end of a cable, such as a power cable, in order to pull it through a tube or tunnel. [1] It works by tightening around the cable when pulled, in the same manner as a Chinese finger trap. [2] The towing sock is tubular and made of braided cable, open at one ...

5. Electrical conduit - Wikipedia

   en.wikipedia.org/wiki/Electrical_conduit

   Flexible metallic conduit (FMC, informally called greenfield or flex) is made by the helical coiling of a self-interlocked ribbed strip of aluminum or steel, forming a hollow tube through which wires can be pulled. FMC is used primarily in dry areas where it would be impractical to install EMT or other non-flexible conduit, yet where metallic ...

6. Wire drawing - Wikipedia

   en.wikipedia.org/wiki/Wire_drawing

   Drawing thicker silver wire by cranked pulling. Wire drawing is a metalworking process used to reduce the cross-section of a wire by pulling the wire through one or more dies. There are many applications for wire drawing, including electrical wiring, cables, tension-loaded structural components, springs, paper clips, spokes for wheels, and ...

7. Knob-and-tube wiring - Wikipedia

   en.wikipedia.org/wiki/Knob-and-tube_wiring

   Earthing systems. v. t. e. Knob-and-tube wiring (sometimes abbreviated K&T) is an early standardized method of electrical wiring in buildings, in common use in North America from about 1880 to the 1930s. [1][2] It consisted of single-insulated copper conductors run within wall or ceiling cavities, passing through joist and stud drill-holes via ...

8. Relay logic - Wikipedia

   en.wikipedia.org/wiki/Relay_logic

   A relay logic circuit is an electrical network consisting of lines, or rungs, in which each line or rung must have continuity to enable the output device. A typical circuit consists of a number of rungs, with each rung controlling an output. This output is controlled by a combination of input or output conditions, such as input switches and ...

9. Electrical wiring - Wikipedia

   en.wikipedia.org/wiki/Electrical_wiring

   Electrical wiring is an electrical installation of cabling and associated devices such as switches, distribution boards, sockets, and light fittings in a structure. Wiring is subject to safety standards for design and installation. Allowable wire and cable types and sizes are specified according to the circuit operating voltage and electric ...