Search results
Results from the WOW.Com Content Network
The rating, developed by the American Society of Heating, Refrigerating and Air Conditioning Engineers, reports a filter’s ability to capture larger participles between 0.3 and 10 microns.
This limit controller may shut the furnace off if the blower fails or if something is blocking the air flow. The heated air is then sent back through the home through supply ducts. In larger commercial applications, central heating is provided through an air handler which incorporates similar components as a furnace but on a larger scale.
[3] [4] Reversing this, connecting the down tube to the source of vacuum, places the inlet of the vacuum directly above the condensate, increasing the chances of vapour phase condensate moving up the (uncooled) down tube (towards the pump) or, should the trap begin to fill to an appreciable volume, liquid phase condensate being pulled into the ...
Furnaces are mostly used as a major component of a central heating system. Furnaces are permanently installed to provide heat to an interior space through intermediary fluid movement, which may be air, steam, or hot water. Heating appliances that use steam or hot water as the fluid are normally referred to as a residential steam boilers or ...
In particular, the problem of 'pluming' arose with early installations of condensing boilers, in which a white plume of condensed vapour (as minuscule droplets) becomes visible at the outlet flue. Although unimportant to boiler operation, visible pluming was an aesthetic issue that caused much opposition to condensing boilers.
Heat traps are valves or loops of pipe on the cold water inlet and hot water outlet of water heaters. The heat traps allow cold water to flow into the water heater tank, but prevent unwanted natural convection and heated water to flow out of the tank. [1] [2] Newer water heaters have built-in heat traps.
Condensate pumps may be used to pump the condensate produced from latent water vapor in any of the following gas mixtures: Conditioned (cooled or heated) building air; Refrigerated air in cooling and freezing systems; Steam in heat exchangers and radiators; The exhaust stream of very-high-efficiency furnaces
Steam traps are nothing more than automatic valves. They open, close or modulate automatically. [1] The three important functions of steam traps are: Discharge condensate as soon as it is formed (unless it is desirable to use the sensible heat of the liquid condensate) Have a negligible steam consumption (i.e. be energy efficient)