enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Hydraulic cylinder - Wikipedia

   en.wikipedia.org/wiki/Hydraulic_cylinder

   A hydraulic cylinder is the actuator or "motor" side of this system. The "generator" side of the hydraulic system is the hydraulic pump which delivers a fixed or regulated flow of oil to the hydraulic cylinder, to move the piston. There are three types of pump widely used: hydraulic hand pump, hydraulic air pump, and hydraulic electric pump.

3. Telescopic cylinder - Wikipedia

   en.wikipedia.org/wiki/Telescopic_cylinder

   Telescopic cylinders must only be used in machinery as a device for providing force and travel. Side forces and moment loads must be minimized. Telescopic cylinders should not be used to stabilize a structural component. [4] Hydraulic telescopic cylinders are often limited to a maximum hydraulic pressure of 2000-3000 psi.

4. Hydraulic machinery - Wikipedia

   en.wikipedia.org/wiki/Hydraulic_machinery

   Hydraulic cylinders; For the hydraulic fluid to do work, it must flow to the actuator and/or motors, then return to a reservoir. The fluid is then filtered and re-pumped. The path taken by hydraulic fluid is called a hydraulic circuit of which there are several types. Open center circuits use pumps that supply a continuous flow.

5. Position-sensing hydraulic cylinder - Wikipedia

   en.wikipedia.org/wiki/Position-sensing_hydraulic...

   The machining and additional production steps associated with “gun drilling” the piston rod can add cost to the finished cylinder. Magnetostrictive LDTs provide extremely high accuracy, down to one micron. [3] Hydraulic cylinder with a Hall effect sensor mounted along its barrel to sense position of a magnetic piston inside. The sensor is ...

6. AOL.com - News, Sports, Weather, Entertainment, Local & Lifestyle

   www.aol.com

   AOL latest headlines, entertainment, sports, articles for business, health and world news.

7. Hydraulic brake - Wikipedia

   en.wikipedia.org/wiki/Hydraulic_brake

   The cylinders and tubes are filled with an incompressible liquid. The two cylinders have the same volume, but different diameters, and thus different cross-section areas. The cylinder that the operator uses is called the master cylinder. The spinning disc brake will be adjacent to the piston with the larger cross-section.