Search results
Results from the WOW.Com Content Network
In aeronautics, a swashplate is a mechanical device that translates input via the helicopter flight controls into motion of the main rotor blades. Because the main rotor blades are spinning, the swashplate is used to transmit three of the pilot's commands from the non-rotating fuselage to the rotating rotor hub and mainblades.
The rudder may also be called upon to counter-act the adverse yaw produced by the roll-control surfaces. If rudder is continuously applied in level flight the aircraft will yaw initially in the direction of the applied rudder – the primary effect of rudder. After a few seconds the aircraft will tend to bank in the direction of yaw.
In February 1976, work commenced to automate the methods contained in the USAF Stability and Control DATCOM, specifically those contained in sections 4, 5, 6 and 7.The work was performed by the McDonnell Douglas Corporation under contract with the United States Air Force in conjunction with engineers at the Air Force Flight Dynamics Laboratory in Wright-Patterson Air Force Base.
Collection of control yokes at Boeing Future of Flight Museum: 747, 707, B-29, Trimotor.The former two yokes are W-shaped, while the latter two are circular. The cockpit of Concorde, which has an M-shaped yoke mounted on a control column The cockpit of an Embraer ERJ with an M-shaped yoke "W"/"U" style yoke in a Cessna 152 light aircraft, mounted on a horizontal tube protruding from the ...
Typical trim tabs on aileron, rudder and elevator. Trim tabs are small surfaces connected to the trailing edge of a larger control surface on a boat or aircraft, used to control the trim of the controls, i.e. to counteract hydro- or aerodynamic forces and stabilise the boat or aircraft in a particular desired attitude without the need for the operator to constantly apply a control force.
Diagram of a falling leaf maneuver. A falling leaf (also called a rudder stall or oscillation stall) is a maneuver in which an aircraft performs a wings-level stall (the airplane stops flying and starts falling) which begins to induce a spin.
A rudder pedal is a foot-operated aircraft flight control interface for controlling the rudder of an aircraft. [1] [2] The usual set-up in modern aircraft is that each pilot has a pedal set consisting of a pair of pedals, with one pedal for each foot. Each right and left pedal works together so that one pedal pops out when the other is ...
The elevator is a usable up and down system that controls the plane, horizontal stabilizer usually creates a downward force which balances the nose down moment created by the wing lift force, which typically applies at a point (the wing center of lift) situated aft of the airplane's center of gravity.