Search results
Results from the WOW.Com Content Network
A typical 12 V, 40 Ah lead-acid car battery. An automotive battery, or car battery, is a rechargeable battery that is used to start a motor vehicle.. Its main purpose is to provide an electric current to the electric-powered starting motor, which in turn starts the chemically-powered internal combustion engine that actually propels the vehicle.
The cold-cranking simulator (CCS) is a device used to determine the low temperature performance of lubricants, when starting a cold engine (i.e. cold-cranking).In this condition, the only energy available to turn the engine comes from the starter motor and the battery, and it has been widely assumed that the system acts as a constant power viscometer.
To assign winter grades, the dynamic viscosity is measured at various cold temperatures, specified in J300, in units of mPa·s, or the equivalent older non-SI units, centipoise (abbreviated cP), using two test methods. They are the cold-cranking simulator (CCS, ASTM D5293) and the mini-rotary viscometer (pumping, ASTM D4684). Each temperature ...
The volt-ampere (SI symbol: VA, [1] sometimes V⋅A or V A) is the unit of measurement for apparent power in an electrical circuit.It is the product of the root mean square voltage (in volts) and the root mean square current (in amperes). [2]
As batteries became more common in cars (due to the increased usage of electric starter motors), magneto systems were replaced by systems using an induction coil.The 1886 Benz Patent-Motorwagen and the 1908 Ford Model T used a trembler coil ignition system, whereby the trembler interrupted the current through the coil and caused a rapid series of sparks during each firing.
A cold start is an attempt to start a vehicle's engine when ambient temperatures are much lower than its normal operating temperature. [1] A cold start can be difficult for an engine due to higher viscosity of oil and fuel in cold temperatures.
A deep-cycle battery powering a traffic signal. A deep-cycle battery is a battery designed to be regularly deeply discharged using most of its capacity. The term is traditionally mainly used for lead–acid batteries in the same form factor as automotive batteries; and contrasted with starter or cranking automotive batteries designed to deliver only a small part of their capacity in a short ...
In electrical engineering, power conversion is the process of converting electric energy from one form to another. A power converter is an electrical device for converting electrical energy between alternating current (AC) and direct current (DC). It can also change the voltage or frequency of the current.