Search results
Results from the WOW.Com Content Network
The inerting systems will probably prevent 8 of those 9 probable explosions, the FAA said. Before the inerting system rule was proposed, Boeing stated that it would install its own inerting system on airliners it manufactures beginning in 2005. Airbus had argued that its planes' electrical wiring made the inerting system an unnecessary expense.
Because an inert purge gas is used, the purge procedure may (erroneously) be referred to as inerting in everyday language. This confusion may lead to dangerous situations. Carbon dioxide is a safe inert gas for purging. Carbon dioxide is an unsafe inert gas for inerting, as it may ignite the vapors and result in an explosion. [2]
Inert gas can also be used to purge the tank of the volatile atmosphere in preparation for gas freeing - replacing the atmosphere with breathable air - or vice versa. The flue gas system uses the boiler exhaust as its source, so it is important that the fuel/air ratio in the boiler burners is properly regulated to ensure that high-quality inert ...
In other cases, a purge-cycle technique is often employed, where the closed, reaction vessel connected to the line is filled with inert gas, evacuated with the vacuum and then refilled. This process is repeated 3 or more times to make sure air is rigorously removed.
A gas bubbler is a piece of laboratory glassware which consists of a glass bulb filled with a small amount of fluid—usually mineral or silicone oil, less commonly mercury. The inlet to the bulb is connected to a ground glass joint, while the outlet is vented to the air. Gas bubblers are used to exclude air from a reaction or a system.
The flammability limits of the gas define those proportions, i.e. the ignitable range. In combustion engineering terms, the admission of inert gas can be said to dilute the oxygen below the limiting oxygen concentration. Inerting differs from purging. Purging, by definition, ensures that an ignitable mixture never forms. Inerting makes an ...
VSA typically draws the gas through the separation process with a vacuum. For oxygen and nitrogen VSA systems, the vacuum is typically generated by a blower. Hybrid vacuum pressure swing adsorption (VPSA) systems also exist. VPSA systems apply pressurized gas to the separation process and also apply a vacuum to the purge gas.
As a tank is pumped out, it's filled with inert gas and kept in this safe state until the next cargo is loaded. [22] The exception is in cases when the tank must be entered. [22] Safely gas-freeing a tank is accomplished by purging hydrocarbon vapors with inert gas until the hydrocarbon concentration inside the tank is under about 1%. [22]