Search results
Results from the WOW.Com Content Network
The ISQ symbols for the bit and byte are bit and B, respectively.In the context of data-rate units, one byte consists of 8 bits, and is synonymous with the unit octet.The abbreviation bps is often used to mean bit/s, so that when a 1 Mbps connection is advertised, it usually means that the maximum achievable bandwidth is 1 Mbit/s (one million bits per second), which is 0.125 MB/s (megabyte per ...
The consumed bandwidth in bit/s, corresponds to achieved throughput or goodput, i.e., the average rate of successful data transfer through a communication path.The consumed bandwidth can be affected by technologies such as bandwidth shaping, bandwidth management, bandwidth throttling, bandwidth cap, bandwidth allocation (for example bandwidth allocation protocol and dynamic bandwidth ...
The physical layer net bitrate, [12] information rate, [6] useful bit rate, [13] payload rate, [14] net data transfer rate, [9] coded transmission rate, [7] effective data rate [7] or wire speed (informal language) of a digital communication channel is the capacity excluding the physical layer protocol overhead, for example time division ...
A typical method of performing a measurement is to transfer a 'large' file from one system to another system and measure the time required to complete the transfer or copy of the file. The throughput is then calculated by dividing the file size by the time to get the throughput in megabits , kilobits , or bits per second.
All higher ratios up to infinity are compressed into the range 100–200%. Ratio bandwidth is often expressed in octaves (i.e., as a frequency level) for wideband applications. An octave is a frequency ratio of 2:1 leading to this expression for the number of octaves, ().
In order to calculate the data transmission rate, one must multiply the transfer rate by the information channel width. For example, a data bus eight-bytes wide (64 bits) by definition transfers eight bytes in each transfer operation; at a transfer rate of 1 GT/s, the data rate would be 8 × 10 9 B/s, i.e. 8 GB/s, or approximately 7.45 GiB/s.
When UI is used as a measurement unit of a time interval, the resulting measure of such time interval is dimensionless. It expresses the time interval in terms of UI. Very often, but not always, the UI coincides with the bit time, i.e. with the time interval taken to transmit one bit (binary information digit).
When instead, the frequency range is (A, A+B), for some A > B, it is called bandpass, and a common desire (for various reasons) is to convert it to baseband. One way to do that is frequency-mixing the bandpass function down to the frequency range (0, B). One of the possible reasons is to reduce the Nyquist rate for more efficient storage.