enow.com Web Search

  1. Ads

    related to: dimming led driver constant current

Search results

  1. Results from the WOW.Com Content Network
  2. 0-10 V lighting control - Wikipedia

    en.wikipedia.org/wiki/0-10_V_lighting_control

    0–10 V is one of the first and simplest electronic lighting control signaling systems, used as an early fluorescent dimming system. [1] Simply put, the control signal is a DC voltage that varies between zero and ten volts. Two standards are recognized: current sourcing and current sinking.

  3. LED circuit - Wikipedia

    en.wikipedia.org/wiki/LED_circuit

    LED drivers are designed to handle fluctuation load, providing enough current to achieve the required brightness while not allowing damaging levels of current to flow. Drivers may be constant current (CC) or constant voltage (CV). In CC drivers, the voltage changes while the current stays the same. CC drivers are used when the electrical load ...

  4. Dimmer - Wikipedia

    en.wikipedia.org/wiki/Dimmer

    This circuit is called a leading-edge dimmer or forward phase dimming. Waveform of the output voltage of a thyristor dimmer set for 60 volts RMS output, with 120 V input. The red trace shows the output device switching on about 5.5 ms after the input (blue) voltage crosses zero.

  5. Digital Addressable Lighting Interface - Wikipedia

    en.wikipedia.org/wiki/Digital_Addressable...

    Digital Addressable Lighting Interface (DALI) is a trademark for network-based products that control lighting.The underlying technology was established by a consortium of lighting equipment manufacturers as a successor for 1-10 V/ 0–10 V lighting control systems, and as an open standard alternative to several proprietary protocols.

  6. Pulse-width modulation - Wikipedia

    en.wikipedia.org/wiki/Pulse-width_modulation

    Adjusting the brightness of light emitted by a light source is then merely a matter of setting at what voltage (or phase) in the AC half-cycle the dimmer begins to provide electric current to the light source (e.g. by using an electronic switch such as a triac). In this case the PWM duty cycle is the ratio of the conduction time to the duration ...

  7. Light-emitting diode - Wikipedia

    en.wikipedia.org/wiki/Light-emitting_diode

    The current in an LED or other diodes rises exponentially with the applied voltage (see Shockley diode equation), so a small change in voltage can cause a large change in current. Current through the LED must be regulated by an external circuit such as a constant current source to prevent damage. Since most common power supplies are (nearly ...

  1. Ads

    related to: dimming led driver constant current