enow.com Web Search

  1. Ads

    related to: automotive 12 volt test light probe

Search results

  1. Results from the WOW.Com Content Network
  2. Test light - Wikipedia

    en.wikipedia.org/wiki/Test_light

    A test light, test lamp, voltage tester, or mains tester is a piece of electronic test equipment used to determine the presence of electricity in a piece of equipment under test. A test light is simpler and less costly than a measuring instrument such as a multimeter , and often suffices for checking for the presence of voltage on a conductor.

  3. Test probe - Wikipedia

    en.wikipedia.org/wiki/Test_probe

    A typical probe uses a 9 megohm series resistor shunted by a low-value capacitor to make an RC compensated divider with the cable capacitance and scope input. The RC time constants are adjusted to match. For example, the 9 megohm series resistor is shunted by a 12.2 pF capacitor for a time constant of 110 microseconds.

  4. Timing light - Wikipedia

    en.wikipedia.org/wiki/Timing_light

    Timing light, combination instrument with RPM, volt meter and dwell angle meter. The actual light is on the far end. The black clamp connects to the battery -, the red clamp to +, the green one to the breaker side of the coil (for RPM), the big black clamp in the foreground is an inductive pick-up that clamps around a spark plug wire.

  5. Category:Electronic test equipment - Wikipedia

    en.wikipedia.org/wiki/Category:Electronic_test...

    Test bench; Test light; Test loop translator; Test probe; Time base generator; Time-domain reflectometer; Total harmonic distortion analyzer; Transformer ratio arm bridge; Transistor tester; Tube tester; Two-tone testing

  6. OBD-II PIDs - Wikipedia

    en.wikipedia.org/wiki/OBD-II_PIDs

    OBD-II PIDs (On-board diagnostics Parameter IDs) are codes used to request data from a vehicle, used as a diagnostic tool.. SAE standard J1979 defines many OBD-II PIDs. All on-road vehicles and trucks sold in North America are required to support a subset of these codes, primarily for state mandated emissions inspections.

  7. Electronic test equipment - Wikipedia

    en.wikipedia.org/wiki/Electronic_test_equipment

    The following items are used for basic measurement of voltages, currents, and components in the circuit under test. Voltmeter (Measures voltage) Ohmmeter (Measures resistance) Ammeter, e.g. Galvanometer or Milliammeter (Measures current) Multimeter e.g., VOM (Volt-Ohm-Milliammeter) or DMM (Digital Multimeter) (Measures all of the above)

  1. Ads

    related to: automotive 12 volt test light probe