enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Swingline - Wikipedia

   en.wikipedia.org/wiki/Swingline

   The Swingline 747 Rio Red The Swingline Commercial Desk Stapler A staple remover. Swingline was founded in 1925 in New York City by Jack Linsky. [2] At that time, it was known as the Parrot Speed Fastener Company and opened its first manufacturing facilities on Varick Street, and in Long Island City in 1931. [2]

3. Hole punch - Wikipedia

   en.wikipedia.org/wiki/Hole_punch

   A hole punch, also known as hole puncher, or paper puncher, is an office tool that is used to create holes in sheets of paper, often for the purpose of collecting the sheets in a binder or folder (such collected sheets are called loose leaves). A hole punch can also refer to similar tools for other materials, such as leather, cloth, or sheets ...

4. Staple (fastener) - Wikipedia

   en.wikipedia.org/wiki/Staple_(fastener)

   A heavy duty office staple might be designated as F1667 STFCC-04: ST indicates staple, FC indicates flat top crown, C indicates cohered (joined into a strip), and 04 is the dash number for a staple with a length of 0.250 inch (6 mm), a leg thickness of 0.020 inch (500 μm), a leg width of 0.030 inch (800 μm), and a crown width of 0.500 inch ...

5. Punch (tool) - Wikipedia

   en.wikipedia.org/wiki/Punch_(tool)

   A punch is a tool used to indent or create a hole through a hard surface. They usually consist of a hard metal rod with a narrow tip at one end and a broad flat "butt" at the other. When used, the narrower end is pointed against a target surface and the broad end is struck with a hammer or mallet , causing the blunt force of the blow to be ...

6. Punching - Wikipedia

   en.wikipedia.org/wiki/Punching

   The punch force required to punch a piece of sheet metal can be estimated from the following equation: [4] F = 0.7 t L ( U T S ) {\displaystyle F=0.7tL(UTS)} Where t is the sheet metal thickness, L is the total length sheared (perimeter of the shape), and UTS is the ultimate tensile strength of the material.

7. Bostitch - Wikipedia

   en.wikipedia.org/wiki/Bostitch

   Stanley Bostitch, previously and more commonly known as simply Bostitch, is an American company that specializes in the design and manufacture of fastening tools (such as staplers, staple guns, nailers, riveters, and glue guns) and fasteners (such as nails, screws, and staples).