enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Dana 35 - Wikipedia

   en.wikipedia.org/wiki/Dana_35

   The Dana/Spicer Model 35 is an automotive axle. It has been manufactured by Dana Holding Corporation since 1985 when American Motors (AMC) sold its axle tooling equipment to Dana. [1] The axle was named AMC-15 when it was first made in 1962. [1] Dana upgraded the axle, and added IFS and Twin Traction Beam front axle variations. Dana 35 from a Jeep

3. AMC and Jeep transmissions - Wikipedia

   en.wikipedia.org/wiki/AMC_and_Jeep_transmissions

   The normal (3") input Dana 18s are interchangeable, but the input gear must match the transfer case. The "big hole" (4" input) Dana 18 is transmission-interchangeable with the Dana 20. Almost all Dana 18 and Dana 20 input gears are 6-spline; the only exception is the one used with the 10-spline version of the T14 transmission.

4. Jeep Comanche - Wikipedia

   en.wikipedia.org/wiki/Jeep_Comanche

   Jeep Comanche Pioneer Jeep Comanche Pioneer interior. The Jeep Comanche (designated MJ) is a pickup truck variant of the Cherokee compact SUV (1984–1992) [3] manufactured and marketed by Jeep for model years 1986-1992 in rear wheel (RWD) and four-wheel drive (4WD) models as well as two cargo bed lengths: six-foot (1.83 meters) and seven-foot (2.13 meters).

5. Jeep Wrangler (JK) - Wikipedia

   en.wikipedia.org/wiki/Jeep_Wrangler_(JK)

   Available as a two-door Wrangler or four-door Wrangler Unlimited, the Rubicon X is a version of Rubicon with electronic-locking front and rear Dana 44 axles, Rock-Trac transfer case with a "4-Low" ratio of 4:1, 4.10 front/rear axle ratio Tru-Lok locking differentials, six-speed manual transmission, BF Goodrich KM 255/75R17 tires, 17-inch ...

6. Dana 44 - Wikipedia

   en.wikipedia.org/wiki/Dana_44

   Dana 44 Front axles were known for utilizing locking hubs or a center axle disconnect system. However, a permanently locked-in Dana 44 is not uncommon. The Dana 44 has seen use in 1/4-, 1/2-, 3/4-, and 1-ton rated trucks. The Dana 44 was manufactured in kingpin and ball joint variations, as well as closed and open knuckle variations.

7. Dana 70 - Wikipedia

   en.wikipedia.org/wiki/Dana_70

   The Dana 70 rear axle was first used in the Dodge W300 in 1958. The Dana 70 started out using 10 spline pinions and 23 spline axle shafts. The later, more current, Dana 70 axles use 29 spline pinions and 32 or 35 spline axle shafts. Dana offered two different limited slip differentials with the Dana 70, the "Powr-Lok" and the "Trac-Lok."