Search results
Results from the WOW.Com Content Network
A number of materials contract on heating within certain temperature ranges; this is usually called negative thermal expansion, rather than "thermal contraction".For example, the coefficient of thermal expansion of water drops to zero as it is cooled to 3.983 °C (39.169 °F) and then becomes negative below this temperature; this means that water has a maximum density at this temperature, and ...
Negative thermal expansion (NTE) is an unusual physicochemical process in which some materials contract upon heating, rather than expand as most other materials do. The most well-known material with NTE is water at 0 to 3.98 °C.
Convection is often categorised or described by the main effect causing the convective flow; for example, thermal convection. Convection cannot take place in most solids because neither bulk current flows nor significant diffusion of matter can take place. Granular convection is a similar phenomenon in granular material instead of fluids.
For a single component system, the "standard" three parameters are the isothermal compressibility , the specific heat at constant pressure , and the coefficient of thermal expansion . For example, the following equations are true:
The Otto Cycle is an example of a reversible thermodynamic cycle. 1→2: Isentropic / adiabatic expansion: Constant entropy (s), Decrease in pressure (P), Increase in volume (v), Decrease in temperature (T) 2→3: Isochoric cooling: Constant volume(v), Decrease in pressure (P), Decrease in entropy (S), Decrease in temperature (T)
The metals involved in a bimetallic strip can vary in composition so long as their thermal expansion coefficients differ. The metal of lower thermal expansion coefficient is sometimes called the passive metal, while the other is called the active metal. Copper, steel, brass, iron, and nickel are commonly used metals in bimetallic strips. [6]
Simulation of thermal convection in the Earth's mantle. Hot areas are shown in red, cold areas are shown in blue. A hot, less-dense material at the bottom moves upwards, and likewise, cold material from the top moves downwards. Convection (or convective heat transfer) is the transfer of heat from one place to another due to the movement of fluid.
To distinguish these two thermal expansion equations of state, the latter one is called pressure-dependent thermal expansion equation of state. To develop the pressure-dependent thermal expansion equation of state, in an compression process at room temperature from (V 0, T 0, P 0) to (V 1, T 0,P 1), a general form of volume is expressed as