Search results
Results from the WOW.Com Content Network
Drill bit sizes are written as irreducible fractions. So, instead of 78/64 inch, or 1 14/64 inch, the size is noted as 1 7/32 inch. Below is a chart providing the decimal-fraction equivalents that are most relevant to fractional-inch drill bit sizes (that is, 0 to 1 by 64ths).
The major minus pitch technique also works for inch-based threads, but you must first calculate the pitch by converting the fraction of threads-per-inch (TPI) into a decimal. For example, a screw with a pitch of 1/20 in (20 threads per inch) has a pitch of 0.050 in and a 1 ⁄ 13 in pitch (13 threads per inch) has a pitch of 0.077 in.
A few sizes are close enough to interchange for most purposes, such as 19 mm (close to 3 ⁄ 4 inch (19.05 mm)), 8 mm (close to 5 ⁄ 16 inch (7.94 mm)) and 4 mm (close to 5 ⁄ 32 inch (3.97 mm)). In reality, a wrench with a width across the flats of exactly 15 mm would fit too tightly to use on a bolt with a width across the flats of 15 mm.
The French scale measures and is proportional to the outer diameter of a catheter, with 1 French (Fr) defined as 1 ⁄ 3 millimeter, making the relationship: 1 mm = 3 Fr. Thus, the outer diameter of a catheter in millimeters can be calculated by dividing the French size by 3. [ 2 ]
English: a ruler from 0 to 1 inch (in.) in 1/32 inch divisions below the line and 1/2 millimetre (mm) divisions above the line to give a visual representation of the approximations. Principally designed to help visually determine if a metric or imperial drill bit will suffice.
Known as "10 mm figure scale" in wargaming circles. [citation needed] 1:160: 1.905 mm: Model railways (N) American and European model trains in N scale. Commonly used for mini armor. 10 mm to 12 mm figure scale for miniature wargaming. 1:152: 2.005 mm 2mm scale / British N scale railway modeling. 1:150: 2.032 mm: Model railways (Japanese N)
For example, a sample from a truckload of peanuts may be placed atop a mesh with 5 mm openings. When the mesh is shaken, small broken pieces and dust pass through the mesh while whole peanuts are retained on the mesh. A commercial peanut buyer might use a test like this to determine if a batch of peanuts has too many broken pieces.
Last, multiply the original expression of the physical value by the fraction, called a conversion factor, to obtain the same physical value expressed in terms of a different unit. Note: since valid conversion factors are dimensionless and have a numerical value of one , multiplying any physical quantity by such a conversion factor (which is 1 ...