Search results
Results from the WOW.Com Content Network
It was founded in 1905 by German immigrant August Ohmstede. It was originally a machine and auto repair shop. In the 1940s, Ohmstede began specializing in the repair and maintenance of heat exchangers. Specifically, Ohmstede performs much field maintenance on shell and tube heat exchangers commonly found in petroleum refineries and ...
The component is removed while the solder is molten, most easily by a spring-loaded puller attached to it before heating. Otherwise all joints must be freed from solder before the component can be removed. Each joint must be heated and the solder removed from it while molten using a vacuum pump, manual desoldering pump, or desoldering braid.
The most common are the models with 50-80 W power. The higher is the power the more amount of heat you may transmit for the same time. It allows reducing the temperature on the heating element to the minimal possible value for melting the solder alloy. And vice versa – the lower is the power the higher temperature you need to melt the solder.
Example of hand held electric heat gun Commercial heat gun kit Flame heat gun for shrinkwrapping helicopter. A heat gun is a device used to emit a stream of hot air, usually at temperatures between 100 and 550 °C (373 and 823 K; 212 and 1,022 °F), with some hotter models running around 760 °C (1,030 K; 1,400 °F), which can be held by hand.
Reflow soldering is a process in which a solder paste (a sticky mixture of powdered solder and flux) is used to temporarily attach anywhere from one to thousands of tiny electrical components to their contact pads, after which the entire assembly is subjected to controlled heat. The solder paste reflows in a molten state, creating permanent ...
A tube of multicore electronics solder used for manual soldering. For attachment of electronic components to a PCB, proper selection and use of flux helps prevent oxidation during soldering; it is essential for good wetting and heat transfer. The soldering iron tip must be clean and pre-tinned with solder to ensure rapid heat transfer.
About 60% of Texas households own at least one gun. Which gun stores sell the most crime-linked guns has been kept secret for more than two decades, since 2003 under the George W. Bush administration.
For low-temperature soldering of heat-sensitive parts, and for soldering in the vicinity of already soldered joints without their remelting. Sn 43 Pb 43 Bi 14: 144: 163 [11] Pb: No: Bi14. Good fatigue resistance combined with low melting point. Contains phases of tin and lead-bismuth. [13] Useful for step soldering. Sn 46 Pb 46 Bi 8: 120: 167 ...