enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   A 5-point can drill through 0.5 in (12.7 mm) of steel, for example. self-tapping machine screw: A self-tapping machine screw is similar to a machine screw, except the lower part of the shank is designed to cut threads as the screw is driven into an untapped hole.

3. Self-tapping screw - Wikipedia

   en.wikipedia.org/wiki/Self-tapping_screw

   A self-tapping screw is a screw that can tap its own hole as it is driven into the material. More narrowly, self-tapping is used only to describe a specific type of thread-cutting screw intended to produce a thread in relatively soft material or sheet materials, excluding wood screws .

4. Tap and die - Wikipedia

   en.wikipedia.org/wiki/Tap_and_die

   The operator guides the tapping head to each (already-drilled) hole and quickly taps it. Drilling and tapping centers, whose name sounds similar to that of tapping stations, are actually light-duty, affordable machining centers of 2, 2.5, or 3 axes that are designed for a life of mainly drilling and tapping with limited milling use.

5. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   Example (inch, coarse): For size 7 ⁄ 16 (this is the diameter of the intended screw in fraction form)-14 (this is the number of threads per inch; 14 is considered coarse), 0.437 in × 0.85 = 0.371 in. Therefore, a size 7 ⁄ 16 screw (7 ⁄ 16 ≈ 0.437) with 14 threads per inch (coarse) needs a tap drill with a diameter of about 0.371 inches.

6. Pocket-hole joinery - Wikipedia

   en.wikipedia.org/wiki/Pocket-hole_joinery

   Self-tapping pocket screws are used for pocket hole joints. Pocket screws are generally more expensive, but they are needed for a tight, strong joint. Pocket screws have a wide washer head to spread the load for a firm bond, and prevent screwing too far into the joint and cracking the wood.

7. Screw - Wikipedia

   en.wikipedia.org/wiki/Screw

   A machine screw or bolt is usually a smaller fastener (less than 1 ⁄ 4 inch (6.35 mm) in diameter) threaded the entire length of its shank that usually has a recessed drive type (slotted, Phillips, etc.), usually intended to screw into a pre-formed thread, either a nut or a threaded (tapped) hole, unlike a wood or self-tapping screw. Machine ...

8. List of DIN standards - Wikipedia

   en.wikipedia.org/wiki/List_of_DIN_standards

   Self-drilling screws with tapping screw thread – Dimensions, requirements and testing: Withdrawn: ISO 10666, ISO 15480, ISO 15481, ISO 15482, ISO 15483: DIN 7513: Hexagon head and slotted head thread cutting screws – Dimensions, requirements and testing: Active: DIN 7516: Cross recessed head thread cutting screws – Dimensions ...

9. List of screw drives - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_drives

   Instead, a one-way screw can be removed by drilling a hole through the head of the screw and inserting a screw extractor. Alternatively, a rotary tool with cutting disk can be used to extend the slot, the head can be gripped with locking pliers, or the screw can be removed with a pin spanner (snake-eyes driver) after drilling two holes in the ...