Search results
Results from the WOW.Com Content Network
Casing Diameters of a Borehole Casing Diagram premium gas tight connections on a casing string. Casing is a large diameter pipe that is assembled and inserted into a recently drilled section of a borehole. Similar to the bones of a spine protecting the spinal cord, casing is set inside the drilled borehole to protect and support the wellstream.
The production liner has the same function as a complete string of production casing. A typical casing arrangement in a well is shown in the diagram below. In this case, the surface casing is set to a depth of about 3,000 ft (910 m). Two intermediate strings are set in this well — a 13 + 3 ⁄ 8 in (340 mm) string and a 9 + 7 ⁄ 8 in (250 mm ...
A liner is a casing string that does not extend to the surface, being hung instead from a liner hanger set inside of the previous casing string but usually within about 300 feet (91 m) of its bottom. Other than the obvious cost savings, the liner installation allows larger drill pipe or production tubing to be used in the upper portions of the ...
Casing flow: means that the producing fluid flow has only one path to the surface through the casing. Casing and tubing flow: means that there is tubing within the casing that allows fluid to reach the surface. This tubing can be used as a kill string for chemical injection.
In a completed well, there may be many annuli. The 'A' annulus is the void between the production tubing and the smallest casing string. The 'A' annulus can serve a number of crucial tasks, including gas lift and well kills. A normal well will also have a 'B' and frequently a 'C' annulus, between the different casing strings.
In the diagram, these are stands of drill pipe which are 2 or 3 joints of drill pipe connected and stood in the derrick vertically, usually to save time while tripping pipe. Drill string (#25) is an assembled collection of drill pipe, heavy weight drill pipe, drill collars and any of a whole assortment of tools, connected and run into the ...
The primary purpose of a wellhead is to provide the suspension point and pressure seals for the casing strings that run from the bottom of the hole sections to the surface pressure control equipment. [1] While drilling the oil well, surface pressure control is provided by a blowout preventer (BOP).
The casing head is prepared with a bowl into which the slips sit and chuck the casing in place. Most casing heads allow for the pressure readings to be taken on the annulus and provide the means to pump out or into if necessary. The top of the casing string and annulus is usually sealed. The most common size of casing hanger is 13 + 3 ⁄ 8 in ...