enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Heated hose - Wikipedia

   en.wikipedia.org/wiki/Heated_hose

   Heated hoses are suitable for environments from -40°C to 80°C and can be used in explosion-proof zones 1/21 and 2/22, if required. [3] A heated hose consists of a flexible hose, through which the media is pumped. This hose determines the resistance against temperature and chemicals.

3. AN thread - Wikipedia

   en.wikipedia.org/wiki/AN_thread

   A 37° flare type end fitting for flexible hose The AN thread (also A-N ) is a particular type of fitting used to connect flexible hoses and rigid metal tubing that carry fluid. It is a US military-derived specification that dates back to World War II and stems from a joint standard agreed upon by the Army Air Corps and Navy, hence AN.

4. Plumbing - Wikipedia

   en.wikipedia.org/wiki/Plumbing

   [8] [9] Clay pipes were later used in the Hittite city of Hattusa. [10] They had easily detachable and replaceable segments, and allowed for cleaning. Standardized earthen plumbing pipes with broad flanges making use of asphalt for preventing leakages appeared in the urban settlements of the Indus Valley civilization by 2700 BC. [11]

5. Hard suction hose - Wikipedia

   en.wikipedia.org/wiki/Hard_suction_hose

   5-inch (13 cm) flex suction hose with Storz fittings, mounted on an engine. Flexible suction hose (Flex suction or suction hose), not to be confused with hard suction hose in U.S., is a specific type of fire hose used in drafting operations, when a fire engine uses a vacuum to draw water from a portable water tank, pool, or other static water source.

6. Pipe (fluid conveyance) - Wikipedia

   en.wikipedia.org/wiki/Pipe_(fluid_conveyance)

   For pipe sizes less than NPS 14 inch (DN 350), both methods give a nominal value for the OD that is rounded off and is not the same as the actual OD. For example, NPS 2 inch and DN 50 are the same pipe, but the actual OD is 2.375 inches or 60.33 millimetres. The only way to obtain the actual OD is to look it up in a reference table.

7. Tankless water heating - Wikipedia

   en.wikipedia.org/wiki/Tankless_water_heating

   A hybrid water heater is a water heating system that integrates technology traits from both the tank-type water heaters and the tankless water heaters. [5] It maintains water pressure and consistent supply of hot water across multiple hot water applications, and like its tankless cousins, it is efficient and can supply a continuous flow of hot ...

8. Water heating - Wikipedia

   en.wikipedia.org/wiki/Water_heating

   In the United States, typical natural gas water heaters for households without unusual needs are 150–190 L (40–50 US gal) with a burner rated at 10.0–11.7 kilowatts (34,000–40,000 BTU/h). This is a popular arrangement where higher flow rates are required for limited periods.

9. Heat pump - Wikipedia

   en.wikipedia.org/wiki/Heat_pump

   An electrical resistance heater has a COP of 1.0, which is considerably lower than a well-designed heat pump which will typically have a COP of 3 to 5 with an external temperature of 10 °C and an internal temperature of 20 °C. Because the ground is a constant temperature source, a ground-source heat pump is not subjected to large temperature ...