enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Circlip - Wikipedia

   en.wikipedia.org/wiki/Circlip

   A circlip (a portmanteau of "circle" and "clip"), also known as a C-clip, snap ring, or ', [1] is a type of fastener or retaining ring that consists of a semi-flexible metal ring with open ends that can be snapped into place into a machined groove on a dowel pin or other part to permit rotation but to prevent axial movement. There are two basic ...

3. Retaining ring - Wikipedia

   en.wikipedia.org/wiki/Retaining_ring

   A retaining ring is a fastener that holds components or assemblies onto a shaft or in a housing/bore when installed - typically in a groove - for one time use only. Once installed, the exposed portion acts as a shoulder which retains the specific component or assembly.

4. Harbor Freight Coupon for 20% Off - AOL

   www.aol.com/news/2011-02-16-harbor-freight...

   Replace old tools or get new ones with this Harbor Freight coupon for 20% off any one item. Expires Feb. 19, 2011. Valid in store, online, or over the phone. Use coupon code 74990607 online or ...

5. Slip joint pliers - Wikipedia

   en.wikipedia.org/wiki/Slip_joint_pliers

   Straight slip joint pliers are configured similarly to common or lineman's pliers in that their jaws are in line with their handles. One side of the pliers usually has two holes that are connected by a slot for the pivot. The pivot is fastened to the other side and shaped such that it can slide through the slot when the pliers are fully opened.

6. Harbor Freight Tools - Wikipedia

   en.wikipedia.org/wiki/Harbor_Freight_Tools

   Harbor Freight Tools won a declassification of the class action; that is, the court found that all the individual situations were not similar enough to be judged as a single class, and that their claims would require an individual-by-individual inquiry, so the case could not be handled on a class basis.

7. Locking pliers - Wikipedia

   en.wikipedia.org/wiki/Locking_pliers

   Locking pliers remain clamped to an object without requiring continuous pressure on the handles based on the "over-center" principle. After being properly adjusted using a threaded screw, the pliers are brought to bear by cam action. In the process of being closed on an object the mechanism passes through a point of maximum tightest clamping ...