enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. List of commercially available roofing materials - Wikipedia

   en.wikipedia.org/wiki/List_of_commercially...

   Membrane roofing consists of large sheets, generally fused in some way at the joints to form a continuous surface. Cured Thermoset membrane (e.g. EPDM rubber, Neoprene). Synthetic rubber Cured Thermosets are synthetic rubbers that have undergone the vulcanization or "Curing" process. Seams of materials are bonded by adhesives or chemicals ...

3. Membrane roofing - Wikipedia

   en.wikipedia.org/wiki/Membrane_roofing

   The finished roof's thickness is usually between 30 and 120 mils (thousandths of an inch; 0.75 mm to 1.50 mm). The most commonly used cured elastomer membranes are ethylene propylene diene monomer (commonly EPDM) and neoprene, although all thermoset products combined fail to account for more than 10% of all commercial roofing. This is in part ...

4. Roof coating - Wikipedia

   en.wikipedia.org/wiki/Roof_coating

   A roof coating is a monolithic, fully adhered, fluid applied roofing membrane. Many roof coatings are elastomeric, that is, they have elastic properties that allow them to stretch and return to their original shape without damage. Typical roof coating dry film thickness vary from paint film thickness (plus or minus 0.075 mm (3 dry mils) to more ...

5. Asphalt roll roofing - Wikipedia

   en.wikipedia.org/wiki/Asphalt_roll_roofing

   Asphalt roll roofing or membrane is a roofing material commonly used for buildings that feature a low sloped roof pitch in North America. The material is based on the same materials used in asphalt shingles ; an organic felt or fiberglass mat, saturated with asphalt , and faced with granular stone aggregate.

6. EPDM rubber - Wikipedia

   en.wikipedia.org/wiki/EPDM_rubber

   EPDM rubber (ethylene propylene diene monomer rubber) [1] [2] [3] is a type of synthetic rubber that is used in many applications. EPDM is an M-Class rubber under ASTM standard D-1418; the M class comprises elastomers with a saturated polyethylene chain (the M deriving from the more correct term polymethylene).

7. Thermoplastic olefin - Wikipedia

   en.wikipedia.org/wiki/ThermoPlastic_Olefin

   The PP and PE components of a blend constitute the "crystalline phase", and the rubber and branched PE chains and PE/PP end groups gives the "amorphous phase". If PP and PE are the dominant component of a TPO blend then the rubber fraction will be dispersed into a continuous matrix of "crystalline" polypropylene.