Ad
related to: fluke calibration meter troubleshooting light codes
Search results
Results from the WOW.Com Content Network
Fluke Corporation is an American manufacturer of industrial test, measurement, and diagnostic equipment, including electronic test equipment. It was started in 1948 by John Fluke while he was employed at General Electric .
In electronics, a continuity test is the checking of an electric circuit to see if current flows (that it is in fact a complete circuit). A continuity test is performed by placing a small voltage (wired in series with an LED or noise-producing component such as a piezoelectric speaker) across the chosen path.
For example, if the meter is set to a range of 300 V full scale, the meter's impedance will be 6 MΩ. 20,000 Ω/V is the best (highest) sensitivity available for typical analog multimeters that lack internal amplifiers. For meters that do have internal amplifiers (VTVMs, FETVMs, etc.), the input impedance is fixed by the amplifier circuit.
The formal definition of calibration by the International Bureau of Weights and Measures (BIPM) is the following: "Operation that, under specified conditions, in a first step, establishes a relation between the quantity values with measurement uncertainties provided by measurement standards and corresponding indications with associated measurement uncertainties (of the calibrated instrument or ...
An OTDR. An optical time-domain reflectometer (OTDR) is an optoelectronic instrument used to characterize an optical fiber.It is the optical equivalent of an electronic time domain reflectometer which measures the impedance of the cable or transmission line under test.
On the display unit, the measured optical power and set wavelength is displayed. Power meters are calibrated using a traceable calibration standard. A traditional optical power meter responds to a broad spectrum of light, however, the calibration is wavelength dependent. This is not normally an issue, since the test wavelength is usually known ...
Most metering units have special modes for calibration and resetting meter registers. These modes are usually protected by anti-tampering features such as switches that sense if the meter enclosure has been opened. The HHU may also be given limited rights to set or reset certain parameters in the meter. The handheld unit then sends a sign-off ...
An electro-optical detector is used to measure the intensity of the light, which is then normally displayed on a screen in a similar manner to a radio- or audio-frequency spectrum analyzer. The input to an optical spectrum analyzer may be simply via an aperture in the instrument's case, an optical fiber or an optical connector to which a fiber ...
Ad
related to: fluke calibration meter troubleshooting light codes