Search results
Results from the WOW.Com Content Network
Non-shrink grout is a hydraulic cement grout that, when hardened under stipulated test conditions, does not shrink, so its final volume is greater than or equal to the original installed volume. It is often used as a transfer medium between load-bearing members.
In the US, it is widely used to rate interior partitions, ceilings, floors, doors, windows and exterior wall configurations. Outside the US, the ISO Sound Reduction Index (SRI) is used. The STC rating very roughly reflects the decibel reduction of noise that a partition can provide. The STC is useful for evaluating annoyance due to speech ...
Grout sealer is a water-based or solvent-based sealant applied over dried grout that resists water, oil, and acid-based contaminants. Grout cleaner is a basic cleaning solution that is applied on grout lines and removes the dirt and dust. [9] A die grinder is used for faster removal of old grout compared to a standard grout saw.
Interior loadbearing walls are framed in the same way as exterior walls. Studs are usually 1 + 1 ⁄ 2 in × 3 + 1 ⁄ 2 in (38 mm × 89 mm) lumber spaced at 16 in (410 mm) on center. This spacing may be changed to 12 or 24 in (300 or 610 mm) depending on the loads supported and the type and thickness of the wall finish used. [12]
A stair flight is a run of stairs or steps between landings. A stairwell is a compartment extending vertically through a building in which stairs are placed. A stair hall is the stairs, landings, hallways, or other portions of the public hall through which it is necessary to pass when going from the entrance floor to the other floors of a building.
Diagram of a revolving door, viewed from above. Around the central shaft of the revolving door, there are usually three or four panels called wings or leaves.Large diameter revolving doors can accommodate pushchairs and wheeled luggage racks - such large capacity doors are sometimes H-shaped to split the circle into only two (hence larger) parts.
Good lighting is important in a staircase so users see where they are going and to prevent falls. [6] There is often a window on the wall to let in daylight.In many cases, indoor stairs are placed far inside the building structure, and it is often not easy to get access to a wall on the outside where it would be natural to have a regular window for letting daylight in.
Pressure grouting or jet grouting [1] involves injecting a grout material into otherwise inaccessible but interconnected pore or void space of which neither the configuration or volume are known, and is often referred to simply as grouting. The grout may be a cementitious, resinous, or solution chemical mixture. Some types of injected grout may ...