Search results
Results from the WOW.Com Content Network
This joint design requires no tooling and is formed naturally as excess mortar is squeezed out from between the bricks. The result is a rustic, textured appearance. This design is not recommended for exterior building walls due to the tendency for exposed mortar to break away, degrading the wall’s appearance. Beaded joint
A double-tee retaining wall Warehouse/office building with double tee wall panels. Double tees have been used in vertical load-bearing members such as exterior walls, [3] and retaining walls. [13] When using load-bearing double tee wall panels, it can significantly reduce construction time as a large area of walls can be covered in a short ...
Interior loadbearing walls are framed in the same way as exterior walls. Studs are usually 1 + 1 ⁄ 2 in × 3 + 1 ⁄ 2 in (38 mm × 89 mm) lumber spaced at 16 in (410 mm) on center. This spacing may be changed to 12 or 24 in (300 or 610 mm) depending on the loads supported and the type and thickness of the wall finish used. [12]
Grout sealer is a water-based or solvent-based sealant applied over dried grout that resists water, oil, and acid-based contaminants. Grout cleaner is a basic cleaning solution that is applied on grout lines and removes the dirt and dust. [9] A die grinder is used for faster removal of old grout compared to a standard grout saw.
Non-shrink grout is a hydraulic cement grout that, when hardened under stipulated test conditions, does not shrink, so its final volume is greater than or equal to the original installed volume. It is often used as a transfer medium between load-bearing members.
Lath and plaster is a building process used to finish mainly interior dividing walls and ceilings. It consists of narrow strips of wood which are nailed horizontally across the wall studs or ceiling joists and then coated in plaster. The technique derives from an earlier, more primitive process called wattle and daub. [1]
A grout curtain is a barrier that protects the foundation of a dam from seepage and can be made during initial construction or during repair. [1] Additionally, they can be used to strengthen foundations and contain spills.
Good lighting is important in a staircase so users see where they are going and to prevent falls. [6] There is often a window on the wall to let in daylight.In many cases, indoor stairs are placed far inside the building structure, and it is often not easy to get access to a wall on the outside where it would be natural to have a regular window for letting daylight in.