Search results
Results from the WOW.Com Content Network
Diagram of double tee beam. A double tee or double-T beam is a load-bearing structure that resembles two T-beams connected to each other side by side. The strong bond of the flange (horizontal section) and the two webs (vertical members, also known as stems) creates a structure that is capable of withstanding high loads while having a long span.
Grout sealer is a water-based or solvent-based sealant applied over dried grout that resists water, oil, and acid-based contaminants. Grout cleaner is a basic cleaning solution that is applied on grout lines and removes the dirt and dust. [9] A die grinder is used for faster removal of old grout compared to a standard grout saw.
A stair flight is a run of stairs or steps between landings. A stairwell is a compartment extending vertically through a building in which stairs are placed. A stair hall is the stairs, landings, hallways, or other portions of the public hall through which it is necessary to pass when going from the entrance floor to the other floors of a building.
Non-shrink grout is a hydraulic cement grout that, when hardened under stipulated test conditions, does not shrink, so its final volume is greater than or equal to the original installed volume. It is often used as a transfer medium between load-bearing members.
The plate assemblies are fabricated off site, and welded together on-site to form steel walls connected by stringers. The walls become the form into which concrete is poured. Steel plate construction speeds reinforced concrete construction by cutting out the time-consuming on-site manual steps of tying rebar and building forms.
This joint design requires no tooling and is formed naturally as excess mortar is squeezed out from between the bricks. The result is a rustic, textured appearance. This design is not recommended for exterior building walls due to the tendency for exposed mortar to break away, degrading the wall’s appearance. Beaded joint
Architects' Data (German: Bauentwurfslehre), also simply known as the Neufert, is a reference book for spatial requirements in building design and site planning.First published in 1936 by Ernst Neufert, [1] its 39 German editions and translations into 17 languages have sold over 500,000 copies. [2]
A setback as a minimum one-bay indent across all stories is called a recessed bay or recess and is the more common exterior form of an alcove. Upper stories forming a step-back may form a belvedere – and in residential use are considered the penthouse. If part of the roof, then they are a loft or attic/garret.