Ad
related to: common rafter length formula for square base of roof
Search results
Results from the WOW.Com Content Network
The hip or valley rafter also connects the ridge to the plate, but lies at a 45-degree angle to the common rafter. This number gives the length of the hip or valley rafter per seventeen units of run. Difference in lengths jacks. The jack rafters lie in the same plane as the common rafter but connect the top plate (the wall) or ridge board to ...
Commonly used roof pitches were given names such as: Greek: the ridge height is 1 ⁄ 9 to 1 ⁄ 7 the span (an angle of 12.5° to 16°); Roman: the ridge height is 2 ⁄ 9 to 1 ⁄ 3 the span (an angle of 24° to 34°); Common: the rafter length is 3 ⁄ 4 the span (about 48°); Gothic: the rafters equal the span (60°); and
A double roof (using a Norman truss), common rafters supported by principal rafters (top chords in this case) and an unusual extra layer of common rafters on the lower half to form a gallerie. Note how the rafter poles for the gallerie tie-in. The Bequet-Ribault House was built c. 1793 near Ste. Geneviève, Missouri. It is one of five poteaux ...
Pyramid roof: A steep hip roof on a square building. Pyatthat: A multi-tiered and spired roof commonly found in Burmese royal and Buddhist architecture. Tented: A type of polygonal hipped roof with steeply pitched slopes rising to a peak; Helm roof, Rhenish helm: A pyramidal roof with gable ends; often found on church towers.
Two king post trusses linked to support a roof. Key:1: ridge beam, 2: purlins, 3: common rafters. This is an example of a "double roof" with principal rafters and common rafters. A timber roof truss is a structural framework of timbers designed to bridge the space above a room and to provide support for a roof.
In the UK, a concrete tiled roof would normally have rafters at 600 mm (24 in) centers, roof battens at 300 mm (12 in) centers and ceiling joists at 400 mm (16 in) centers. The United States still uses imperial units of measurement and framing members are typically spaced sixteen or twenty-four inches apart.
Deflection (f) in engineering. In structural engineering, deflection is the degree to which a part of a long structural element (such as beam) is deformed laterally (in the direction transverse to its longitudinal axis) under a load.
Rafter – is one of a series of sloped structural members that extend from the ridge or hip to the wall plate, downslope perimeter or eave, and that are designed to support the roof deck and its associated loads. [30] A pair of rafters is called a couple. In home construction, rafters are normally made of wood. Exposed rafters are a feature of ...
Ad
related to: common rafter length formula for square base of roof