Search results
Results from the WOW.Com Content Network
Offset printing is a common printing technique in which the inked image is transferred (or "offset") from a plate to a rubber blanket and then to the printing surface. When used in combination with the lithographic process, which is based on the repulsion of oil and water , the offset technique employs a flat ( planographic ) image carrier.
The problem can occur with most types of printing, and is avoided by the use of slipsheets between copies (so any ink transfer occurs onto discardable paper) or anti-set-off spray powder. The term in offset printing also refers to the unwanted transfer of ink to rollers and friction points throughout the printing press. Ink that is not properly ...
Waterless offset presses do not use a dampening solution to keep the plate's non-image areas free of ink. These presses function because the plate's non-image areas consist of a layer of silicone that repels ink. A waterless press resembles a conventional offset press, with the absence of a dampening system.
[8] [9] Offset printing or "offset lithography" is an elaboration of lithography in which the ink is transferred from the plate to the paper indirectly by means of a rubber plate or cylinder, rather than by direct contact. This technique keeps the paper dry and allows fully automated high-speed operation.
The offset process employs a flat (planographic) image carrier (plate) which is mounted on a press cylinder. The image to be printed obtains ink from ink rollers, while the non-printing area attracts an (acidic) film of water, keeping the non-image areas ink-free. Most offset presses use three cylinders: Plate, blanket, impression.
The term camera-ready was first used in the photo offset printing process, where the final layout of a document was attached to a "mechanical" or "paste up".Then, a stat camera was used to photograph the mechanical, and the final offset printing plates were created from the camera's negative.
A rotary printing press is a printing press in which the images to be printed are curved around a cylinder. Printing can be done on various substrates, including paper, cardboard, and plastic. Printing can be done on various substrates, including paper, cardboard, and plastic.
In printing, trap expresses the degree to which ink already printed on a substrate accepts another layer printed on top of it compared to how well the substrate (e.g., paper) accepts that ink. However, in the era of prepress software, the term came to refer to compensation for misregistration (when two layers of ink are not perfectly aligned ...