Ads
related to: metal engraving processtemu.com has been visited by 1M+ users in the past month
reviews.chicagotribune.com has been visited by 100K+ users in the past month
Search results
Results from the WOW.Com Content Network
Other terms often used for printed engravings are copper engraving, copper-plate engraving or line engraving. Steel engraving is the same technique, on steel or steel-faced plates, and was mostly used for banknotes, illustrations for books, magazines and reproductive prints, letterheads and similar uses from about 1790 to the early 20th century, when the technique became less popular, except ...
Engraving is done with a burin, which is a small bar of hardened steel with a sharp point. It is pushed along the plate to produce thin furrowed lines, leaving "burr" or strips of waste metal to the side. This is followed by the use of a scraper to remove any burs, since they would be an impediment during the subsequent inking process.
Etching by Daniel Hopfer, who is believed to have been the first to apply the technique to printmaking. Etching is traditionally the process of using strong acid or mordant to cut into the unprotected parts of a metal surface to create a design in intaglio (incised) in the metal. [1] In modern manufacturing, other chemicals may be used on other ...
Laser engraving. Laser marked electronic part. Laser engraving is the practice of using lasers to engrave an object. The engraving process renders a design by physically cutting into the object to remove material. The technique does not involve the use of inks or tool bits that contact the engraving surface and wear out, giving it an advantage ...
Photoengraving is a process that uses a light-sensitive photoresist applied to the surface to be engraved to create a mask that protects some areas during a subsequent operation which etches, dissolves, or otherwise removes some or all of the material from the unshielded areas of a substrate. Normally applied to metal, it can also be used on ...
In intaglio printing, the lines to be printed are cut into a metal (e.g. copper) plate by means either of a cutting tool called a burin, held in the hand – in which case the process is called engraving; or through the corrosive action of acid – in which case the process is known as etching.
Ads
related to: metal engraving processtemu.com has been visited by 1M+ users in the past month
reviews.chicagotribune.com has been visited by 100K+ users in the past month