Search results
Results from the WOW.Com Content Network
The design of the saturable inductor current sensor is similar to that of a closed-loop Hall-effect current sensor; the only difference is that this method uses the saturable inductor instead of the Hall-effect sensor in the air gap. Saturable inductor current sensor is based on the detection of an inductance change. The saturable inductor is ...
Ideally the measuring device should not affect the circuit parameters i.e., the internal impedance of the ammeter should be zero (no voltage drop over the ammeter) and the internal impedance of the voltmeter should be infinite (no current through the voltmeter). However, in actual case, ammeters have a low but non zero impedance and voltmeters ...
The output power of a TV transmitter is the electric power applied to antenna system. There are two definitions: nominal (or peak) and thermal. Analogue television systems put about 70% to 90% of the transmitters power into the sync pulses. The remainder of the transmitter's power goes into transmitting the video's higher frequencies and the FM ...
The company was founded in 2002 as V Inc. by entrepreneur William Wang and two founding employees. [5] [6] [7] By 2004, Wang changed the company name to Vizio.[8] [9]In 2006, the company's revenue was estimated at $700 million, and in 2007 it was estimated to have exceeded $2 billion. [10]
Current can also be measured without breaking the circuit by detecting the magnetic field associated with the current. Devices, at the circuit level, use various techniques to measure current: Shunt resistors [18] Hall effect current sensor transducers; Transformers (however DC cannot be measured) Magnetoresistive field sensors [19] Rogowski coils
Illustration of the "reference directions" of the current (), voltage (), and power () variables used in the passive sign convention.If positive current is defined as flowing into the device terminal which is defined to be positive voltage, then positive power (big arrow) given by the equation = represents electric power flowing into the device, and negative power represents power flowing out.
IEC 60417-5007, [6] the power-on symbol (line), appearing on a button or one end of a toggle switch indicates that the control places the equipment into a fully powered state. (1 or | means on.) IEC 60417-5008, [7] the power-off symbol (circle) on a button or toggle, indicates that using the control will disconnect power to the device. (0 or ...
Demonstration model of a moving iron ammeter. As the current through the coil increases, the plunger is drawn further into the coil and the pointer deflects to the right. An ammeter (abbreviation of ampere meter) is an instrument used to measure the current in a circuit. Electric currents are measured in amperes (A), hence the name. For direct ...