Search results
Results from the WOW.Com Content Network
A key exchange block may only hold and release keys and may not have a bolt to interlock process equipment, or may be part of the interlock of a particular machine or device. This is a transfer block, part of a trapped-key interlock system. It does not have a bolt to stop operation of a device, but holds and releases other keys.
The interlock device is located inside the vehicle, near the driver’s seat, and is directly connected to the engine’s ignition system. [1] It is a form of electronic monitoring . An ignition interlock interrupts the signal from the ignition to the starter until a valid breath sample is provided that meets maximal alcohol guidelines in that ...
The key will not turn unless the remaining keys are put back in place. Trapped key interlock transfer block. Another example is an electric kiln. To prevent access to the inside of an electric kiln, a trapped key system may be used to interlock a disconnecting switch and the kiln door. While the switch is turned on, the key is held by the ...
Thieves use a radio relay system to amplify the signal from a key inside someone's home so that they can break into the car in the driveway. While there are multiple ways of opening a car with a ...
Car key in ignition Car ignition and steering wheel lock. A car key or an automobile key is a key used to open and/or start an automobile. Modern key designs are usually symmetrical, and some use grooves on both sides, rather than a cut edge, to actuate the lock. It has multiple uses for the automobile with which it was sold.
EN 50436 is a series of European Standards for ignition interlock devices (also called 'alcohol interlocks') on motor vehicles.. An alcohol interlock consists of two main components: an instrument that measures breath alcohol via a mouthpiece inside the vehicle, and a control unit (normally installed under the dashboard) which controls the current supply to the vehicle's starter relay.
The electric immobiliser/alarm system was invented by St. George Evans and Edward Birkenbeuel and patented in 1919. [2] They developed a 3x3 grid of double-contact switches on a panel mounted inside the car so when the ignition switch was activated, current from the battery (or magneto) went to the spark plugs allowing the engine to start, or immobilizing the vehicle and sounding the horn. [3]
A vehicle might use a chirp system: two beeps on driver door unlocking, four beeps on unlocking of all doors, a long beep for the trunk or power tailgate or a short beep on locking and arming of the alarm. The functions of a remote keyless entry system are contained on a key fob or built into the ignition key handle itself. Buttons are ...