Search results
Results from the WOW.Com Content Network
The explanation of the machine tool regenerative chatter was made by Tobias. S. A. and W. Fishwick in 1958, [2] by modeling the feedback loop between the metal cutting process and the machine tool structure, and came with the stability lobes diagram. The structure stiffness, damping ratio and the machining process damping factor, are the main ...
For example, high vibration at the frequency corresponding to the speed of rotation is most often due to residual imbalance and is corrected by balancing the machine. A degrading rolling-element bearing , on the other hand, will usually exhibit vibration signals at specific frequencies increasing in intensity as it wears.
Over time, the sound level dissipates, as the vibration amplitude decays to an undetectable level. When vibration is the excitation causing resonance (rather than a hammer blow [such as the strike of a bell]), there is a time period between the beginning of vibration excitation, and the moment when full resonant amplitude is reached.
Its high-frequency characteristics differentiate it from a normal vibrating screen. High-frequency vibrating screens usually operate at an inclined angle, traditionally varying between 0° and 25° and can go up to a maximum of 45°. They should operate with a low stroke and have a frequency ranging from 1500 to 9000 RPM. Frequency in High ...
Vibration isolation is the prevention of transmission of vibration from one component of a system to others parts of the same system, as in buildings or mechanical systems. [1] Vibration is undesirable in many domains, primarily engineered systems and habitable spaces, and methods have been developed to prevent the transfer of vibration to such ...
Use of the vibration-fatigue methods is well-suited, as structural analysis is studied in the frequency-domain. Common practice in the automotive industry is the use of accelerated vibration tests. During the test, a part or a product is exposed to vibration, that are in correlation with those expected during the service-life of the product. To ...
The frequency and amplitude of the machine controls the finish of the parts. The frequencies can vary from 900 to 3600 cycles per minute (CPM) [1] and the amplitude can vary from 0 to 3 ⁄ 16 in (4.76 mm). High frequencies, 1800 CPM or greater, and small amplitudes are used for fine finishes or delicate parts, whereas large amplitudes are used ...
Frequency refers to how many times per second a vibration cycle is completed. Most machinery runs at 120 Hz, although machinery is available that runs from 100–240 Hz. Frequency is dependent on the mass of the vibrating assembly, and as such can only be changed by switching out components of the assembly.