Search results
Results from the WOW.Com Content Network
Damp-proofing rods use similar active ingredients to those found in liquid or cream-based rising damp treatments, but contained in a solid rod. They are generally considered to be easier to use than other types of rising damp treatment as the method of installation is simply to insert them into the correct sized holes drilled into a mortar bed.
Formwork for beams takes the form of a box that is supported and propped in the correct position and level. The removal time for the formwork will vary with air temperature, humidity and consequent curing rate. Typical striking times are as follows (using air temperature of 7-16 °C): Form work. Beam sides: 9–12 hours. Beam soffits: 8–14 days.
Walls appear to be bowed inward. Peeling paint: Water seeping through walls may lead to bubbling or peeling paint along basement walls. [4] Efflorescence: White, powdery residue found on basement walls near the floor. Mold: Fungi that usually grow in damp, dark areas and can cause respiratory problems after prolonged exposure.
Rising damp is the effect of water rising from the ground into property. [3] The damp proof course may be horizontal or vertical. [4] A DPC layer is usually laid below all masonry walls, regardless if the wall is a load bearing wall or a partition wall. A damp-proof membrane (DPM) is a membrane material
Masonry walls are built with a damp-proof course to prevent rising damp, and the concrete in foundations needs to be damp-proofed or waterproofed with a liquid coating, basement waterproofing membrane (even under the concrete slab floor where polyethylene sheeting is commonly used), or an additive to the concrete.
In most climates it is often better to have a vapor-open building assembly, meaning that walls and roofs should be designed to dry: [6] either to the inside, the outside, or both, so the ventilation of water vapor should be taken into consideration. A vapor barrier on the warm side of the envelope must be combined with a venting path on the ...
Modular CE is built in grain bags or similar tubes. Walls rely on attachment between barbed wire barbs and/ or added pins between courses. Solid CE is hyperadobe built in some type of knit raschel mesh tube, so that the damp earthen fill solidifies between courses.
Construction block made from hempcrete Illustration of hemp concrete carbon emissions and sequestration, with a net emissions balance indicating carbon negativity. Hempcrete or hemplime is biocomposite material, a mixture of hemp hurds and lime, [1] sand, or pozzolans, which is used as a material for construction and insulation. [2]