Search results
Results from the WOW.Com Content Network
Bleed air in aerospace engineering is compressed air taken from the compressor stage of a gas turbine, upstream of its fuel-burning sections.Automatic air supply and cabin pressure controller (ASCPC) valves bleed air from low or high stage engine compressor sections; low stage air is used during high power setting operation, and high stage air is used during descent and other low power setting ...
Air bled from the engine fan is blown across the pre-cooler, located in the engine strut, and absorbs excess heat from the service bleed air. A fan air modulating valve (FAMV) varies the cooling airflow to control the final air temperature of the service bleed air. Notably, the Boeing 787 does not use bleed air to pressurize the cabin.
Low pressure (40–70 psi or 280–480 kPa), high volume air from the compressor section of the APU is bled off through a system of pipes to the engines where it is directed into the starting system. This bleed air is directed into a mechanism to start the engine turning and begin pulling in air. The starter is usually an air turbine type ...
While modern engines with advanced control units can avoid many causes of stall, jet aircraft pilots must continue to take this into account when dropping airspeed or increasing throttle. A compressor anti-stall system is a compressor bleed system that automatically dumps away unwanted air to prevent compressor stalling. [5]
By the time the cold outside air has reached the bleed air valves, it has been heated to around 200 °C (392 °F). The control and selection of high or low bleed sources is fully automatic and is governed by the needs of various pneumatic systems at various stages of flight. Piston-engine aircraft require an additional compressor, see diagram ...
The company's first major product was an oil cooler for military aircraft. Garrett designed and produced oil coolers for the Douglas DB-7. [9] Boeing's B-17 bombers, credited with substantially tipping the air war in America's and Great Britain's favor over Europe and the Pacific, were outfitted with Garrett intercoolers, as was the B-25. [12]
Bleed air systems are used by most large aircraft with jet engines or turboprops. Hot air is "bled" off one or more engines' compressor sections into tubes routed through wings, tail surfaces, and engine inlets. Spent air is exhausted through holes in the wings' undersides. A disadvantage of these systems is that supplying an adequate amount of ...
Bleed screws are not common on cars today and are only necessary when design of an engine's cooling system results in areas where air can be trapped in the system. [citation needed] Air in the system can lead to overheating of the engine and in modern cars also to poor vehicle operation (e.g. problems with the AC system or incorrect engine idle).