Search results
Results from the WOW.Com Content Network
BBFuino come with the ATmega328 controller, loaded with Optiboot (Arduino UNO's bootloader), compatible with Arduino IDE and sample code, design to fit breadboard for prototyping and learning, lower down the cost by taking out the USB to UART IC, so the board has the basic component to operate.
The word "uno" means "one" in Italian and was chosen to mark a major redesign of the Arduino hardware and software. [7] The Uno board was the successor of the Duemilanove release and was the 9th version in a series of USB-based Arduino boards. [8] Version 1.0 of the Arduino IDE for the Arduino Uno board has now evolved to newer releases. [4]
A sketch is a program written with the Arduino IDE. [72] Sketches are saved on the development computer as text files with the file extension .ino. Arduino Software (IDE) pre-1.0 saved sketches with the extension .pde. A minimal Arduino C/C++ program consists of only two functions: [73]
Code::Blocks (EPS edition) (debug with ST-LINK no GDB and no OpenOCD required) [35] IDE for Arduino ARM boards. Arduino [note 5] – IDE for Atmel SAM3X (Arduino Due) Energia – Arduino IDE for Texas Instruments Tiva and CC3200; Notes:
The Crumbuino-Mega is a low-cost module comparable to the Arduino-Mega 2560 and can be used as Arduino-Mega 2560 in the Arduino-IDE. The Arduino bootloader is preloaded, hence the module is ready-to-use. The documentation shows the pin mapping of Arduino-naming to module pinout. Cuteduino: Cytron Technologies: ATtiny85 Cuteduino Features:
The ICE is supported by the Microchip Studio IDE, as well as a command line interface (atprogram). The Atmel-ICE supports a limited implementation of the Data Gateway Interface (DGI) when debugging and programming features are not in use. The Data Gateway Interface is an interface for streaming data from a target device to the connected computer.
The hardware design is very similar to the Arduino Leonardo, [12] with some added pull-up resistors and indication LED's. Because of the similarities you can easily turn a regular Arduino Leonardo into a Makey Makey compatible device. [13] You can also program the official Makey Makey using the Arduino IDE. [14]
The BASIC Stamp is programmed in a variant of the BASIC language, called PBASIC. PBASIC incorporates common microcontroller functions, including PWM, serial communications, I²C and 1-Wire communications, communications with common LCD driver circuits, hobby servo pulse trains, pseudo-sine wave frequencies, and the ability to time an RC circuit which may be used to detect an analog value.