Search results
Results from the WOW.Com Content Network
Paraformaldehyde can be depolymerized to formaldehyde gas by dry heating [2] and to formaldehyde solution by water in the presence of a base, an acid or heat. The high purity formaldehyde solutions obtained in this way are used as a fixative for microscopy and histology. The resulting formaldehyde gas from dry heating paraformaldehyde is flammable.
A prominent example is the bacterial mesosome, which was thought to be an organelle in gram-positive bacteria in the 1970s, but was later shown by new techniques developed for electron microscopy to be simply an artifact of chemical fixation. [2] [3] Standardization of fixation and other tissue processing procedures takes this introduction of ...
A saturated water solution, of about 40% formaldehyde by volume or 37% by mass, is called "100% formalin". A small amount of stabilizer, such as methanol, is usually added to suppress oxidation and polymerization. A typical commercial-grade formalin may contain 10–12% methanol in addition to various metallic impurities.
This page contains tables of azeotrope data for various binary and ternary mixtures of solvents. The data include the composition of a mixture by weight (in binary azeotropes, when only one fraction is given, it is the fraction of the second component), the boiling point (b.p.) of a component, the boiling point of a mixture, and the specific gravity of the mixture.
The following compounds are liquid at room temperature and are completely miscible with water; ... 2 CO: acetone: 67-64-1 CH 3 ... methanol: 67-56-1 CH 3 N(C 2 H 4 OH ...
This Wikipedia page provides a comprehensive list of boiling and freezing points for various solvents.
Methanol for chemical use normally corresponds to Grade AA. In addition to water, typical impurities include acetone and ethanol (which are very difficult to separate by distillation). UV-vis spectroscopy is a convenient method for detecting aromatic impurities. Water content can be determined by the Karl-Fischer titration.
Water. Most arterial solutions are a mix of some of the preceding chemicals with tepid water. Cases done without the addition of water are referred to as "waterless." Waterless embalming is more common in difficult cases or those requiring a very high degree of preservation, such as instances of an extended delay between death and final ...