enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Molex connector - Wikipedia

   en.wikipedia.org/wiki/Molex_connector

   As SATA becomes more prevalent, Molex connectors can be found repurposed, through use of an adaptor, to serve as six-pin PCIe power connectors to make up for a lack of such connectors on a power supply. Lower power devices (e.g. 3.5-inch floppy drives) use the smaller AMP 171822-4 connector instead.

3. Lightning (connector) - Wikipedia

   en.wikipedia.org/wiki/Lightning_(connector)

   Lightning is an 8-pin digital connector. Unlike the 30-pin dock connector it replaced (and USB Type-A and -B connectors), it is reversible. [23] Most Lightning devices only support USB 2.0, which has a maximum transfer speed of 480 Mbit/s or 60 MB/s. With USB 2.0, only one lane is in use at a time.

4. Berg connector - Wikipedia

   en.wikipedia.org/wiki/Berg_connector

   Some of the more familiar ones used in IBM PC compatibles are: the four-pin polarized Berg connectors used to connect 3½-inch floppy disk drive units to the power supply unit, usually referred to as simply a "floppy power connector", but often also referred to as LP4. This connector has a 2.50 mm (0.098 in) pitch (not 2.54 mm).

5. MagSafe - Wikipedia

   en.wikipedia.org/wiki/MagSafe

   The computer makes use of this to retrieve information about the power adapter and to change the color of the LEDs on the power adapter's connector. The Apple MagSafe power adapter's 1-Wire communication chip is located inside the MagSafe connector itself; the cable does not carry the data line to the power adapter enclosure. [18]

6. USB hardware - Wikipedia

   en.wikipedia.org/wiki/USB_hardware

   The 24-pin double-sided connector provides four power–ground pairs, two differential pairs for USB 2.0 data (though only one pair is implemented in a USB-C cable), four pairs for SuperSpeed data bus (only two pairs are used in USB 3.1 mode), two "sideband use" pins, V CONN +5 V power for active cables, and a configuration pin for cable ...

7. DC connector - Wikipedia

   en.wikipedia.org/wiki/DC_connector

   In the broadcast, film, and television industries, the 4-pin XLR connector is the standard for 12 V power. The connectors are wired pin 1 negative, pin 4 positive. Often pins 1 and 2 will be negative, 3 and 4 positive for a higher current rating. Female connectors are used as supply and male connectors are used on loads.