Search results
Results from the WOW.Com Content Network
More than two teleprinters could be connected on a single circuit allowing a simple form of networking. [1] Older teleprinters used a 60 mA current loop. Later machines, such as the Teletype Model 33 , operated on a lower 20 mA current level and most early minicomputers featured a 20 mA current loop interface, with an RS-232 port generally ...
To allow the construction of hybrid systems, where the 4–20 mA is generated by the controller, but allows the use of pneumatic valves, a range of current to pressure (I to P) converters are available from manufacturers. These are usually local to the control valve and convert 4–20 mA to 3–15 psi (or 0.2–1.0 bar).
4-digit counter/display driver 16 MM74C925: 74x926 1 4-digit decade counter/display driver, carry out and latch (up to 9999) 16 MM74C926: 74x927 1 4-digit timer counter/display driver (up to 9599, intended as time elapsed, i.e. 9:59.9 min) 16 MM74C927: 74x928 1 4-digit counter/display driver (up to 1999) 16 MM74C928: 74x929 1
Model Description WD1402A The first single-chip UART on general sale. Introduced about 1971. Compatible chips included the Fairchild TR1402A and the General Instruments AY-5-1013. [11] Exar XR21V1410 Intersil 6402 CDP 1854 (RCA, now Intersil) Zilog Z8440 Universal synchronous and asynchronous receiver-transmitter (USART). 2000 kbit/s.
This page was last edited on 13 March 2007, at 22:35 (UTC).; Text is available under the Creative Commons Attribution-ShareAlike 4.0 License; additional terms may ...
The action caused by an impulse on a wire depended on when in the cycle it occurred, a simple form of time-division multiplexing. Thus an impulse that occurred during 7-time on a wire connected to the column 26 punch magnet would punch a hole in row 7 of column 26. An impulse on the same wire that occurred at 4-time would punch a 4 in column 26.
An analogue switch: Maxim MAX313. An analogue switch, also called a bilateral switch, is an electronic component that behaves in a similar way to a relay, but has no moving parts. The switching element is normally a pair of MOSFET transistors, one an N-channel device, the other a P-channel device. The device can conduct analog or digital ...
An absolute encoder maintains position information when power is removed from the encoder. [5] The position of the encoder is available immediately on applying power. The relationship between the encoder value and the physical position of the controlled machinery is set at assembly; the system does not need to return to a calibration point to maintain position accuracy.