Search results
Results from the WOW.Com Content Network
It is very common in blogs and websites to incorrectly name a specific connector only by the name of the manufacturer. To minimize confusion, it is best to describe a connector using: the manufacturer's name, exact connector series, and optionally the pitch, such as "JST-XH" or "JST-XH-2.50mm" or "2.50mm JST XH-series" or other variations.
A MIL-DTL-38999 circular connector plated with a nickel–teflon composite. Left: plug (male) type connector; Right: receptacle (female) type connector) Electrical or fiber-optic connectors used by U.S. Department of Defense were originally developed in the 1930s for severe aeronautical and tactical service applications, and the Type "AN" series set the standard for modern military circular ...
DC power connectors come in a wide variety of shapes and sizes, and there is unfortunately little standardization to their use. This is a large enough problem that some of the connectors that do have well-defined specifications are frequently used contrary to those specifications.
The corresponding notch in the female connector body is 1.8 ± 0.1 mm (0.071 ± 0.004 in) wide and ends at a radius of 6.2 ± 0.1 mm (0.244 ± 0.004 in) from the connector centre. With the angles measured clockwise looking at the female connector (counter-clockwise looking at the male), the various key positions indicate:
1 Mini-DIN 4-pin, 1 Mini-DIN 7-pin, 1 Mini-VGA, 2 BNC, 2 RCA connectors, 8-pin DIN, [4] SCART 21-pin: S-VHS, some laptop computers, analog broadcast video, 1980-1990s home computers including the Commodore 64, C128 and Atari 8-bit computers: The 4-pin mini-DIN that is most common in consumer products today debuted in JVC's 1987 S-VHS. The 7-pin ...
The micro ribbon or miniature ribbon connector is a common type of electrical connector for a variety of applications, such as in computer and telecommunications equipment having many contacts. The connector contains two parallel rows of contacts within a shielded case having a characteristic D-shape similar to that used in D-subminiature ...
Pin 1 is typically indicated on the body of the connector by a red or raised "V" mark. The corresponding wire in a ribbon cable is usually indicated by red coloration, a raised molded ridge, or markings printed onto the cable insulation. On the connector pin 2 is opposite pin 1, pin 3 is next to pin 1 along the length of the connector, and so on.
A connection standard, such as RJ11, specifies not only the physical aspects of an electrical connector, but also the signal definitions for each contact, and the pinout of the device, i.e. the assignment or function of each contact. [1] Modular connectors are specified for the registered jack (RJ) series of connectors, as well as for Ethernet ...