Search results
Results from the WOW.Com Content Network
Subduction zones host a unique variety of rock types formed by the high-pressure, low-temperature conditions a subducting slab encounters during its descent. [4] The metamorphic conditions the slab passes through in this process generates and alters water bearing (hydrous) mineral phases, releasing water into the mantle.
Obduction zones occurs when the continental plate is pushed under the oceanic plate, but this is unusual as the relative densities of the tectonic plates favours subduction of the oceanic plate. This causes the oceanic plate to buckle and usually results in a new mid-ocean ridge forming and turning the obduction into subduction. [citation needed]
Subduction zone physics: Sinking of the oceanic lithosphere (sediments, crust, mantle), by the contrast of density between the cold and old lithosphere and the hot asthenospheric mantle wedge, is the strongest force (but not the only one) needed to drive plate motion and is the dominant mode of mantle convection. [citation needed]
The figure is a schematic diagram depicting a subduction zone. The subduction slab on the right enters the mantle with a varying temperature gradient while importing water in a downward motion. A model of the subducting Farallon slab under North America. In geology, the slab is a significant constituent of subduction zones. [1]
A volcanic arc is part of an arc-trench complex, which is the part of a subduction zone that is visible at the Earth's surface. A subduction zone is where a tectonic plate composed of relatively thin, dense oceanic lithosphere sinks into the Earth's mantle beneath a less dense overriding plate. The overriding plate may be either another oceanic ...
The subduction of bathymetric highs such as aseismic ridges, oceanic plateaus, and seamounts has been posited as the primary driver of flat slab subduction. [3] The Andean flat slab subduction zones, the Peruvian slab and the Pampean (Chilean) flat slab, are spatially correlated with the subduction of bathymetric highs, the Nazca Ridge and the Juan Fernandéz Ridge, respectively.
Oblique subduction has led to rotation of microblocks about nearby poles of rotation (See also: Euler poles) in some oblique subduction zones. [39] In these regions, the trench parallel strike slip fault systems are less prominent. [12] This is because a portion of the trench parallel component is accommodated by the microblock rotation. [12]
Diagram of a cross-section of the Patagonia slab window. The Nazca plate and Antarctic plate are colliding with the South American plate at the Chile Ridge. [1]In geology, a slab window is a gap that forms in a subducted oceanic plate when a mid-ocean ridge meets with a subduction zone and plate divergence at the ridge and convergence at the subduction zone continue, causing the ridge to be ...