Search results
Results from the WOW.Com Content Network
Another method of reducing the fan speed [5] is by moving the 5 V wire in the classical Molex power connector in the place of the Ground wire going to the fan, thereby delivering +7 V (12 V − 5 V = 7 V) to the fan. However, this is a potentially risky method, because +5 V PSU line is intended to source current only, not sink it, so the PSU is ...
From a control standpoint, the main difference between PECI and the previously used thermal monitoring methods is that PECI reports a negative value expressing the difference between the current temperature and the thermal throttle point (at which the CPU reduces speed or shuts down to prevent damage due to overheating) instead of the absolute ...
[12] [13] [14] In September 2004, revision 3.0 was released, bringing to the ACPI specification support for SATA interfaces, PCI Express bus, multiprocessor support for more than 256 processors, ambient light sensors and user-presence devices, as well as extending the thermal model beyond the previous processor-centric support.
Where noise is an issue, larger, slower-turning fans are quieter than smaller, faster fans that can move the same airflow. Fan noise has been found to be roughly proportional to the fifth power of fan speed; halving the speed reduces the noise by about 15 dB. [22] Axial fans may rotate at speeds of up to around 38,000 rpm for smaller sizes. [23]
SpeedFan is a system monitor for Microsoft Windows that can read temperatures, voltages and fan speeds of computer components. [3] It can change computer fan speeds depending on the temperature of various components. [1] [4] The program can display system variables as charts and as an indicator in the system tray.
Under the Hub Architecture, a motherboard would have a two piece chipset consisting of a northbridge chip and a southbridge chip. Over time, the speed of CPUs kept increasing but the bandwidth of the front-side bus (FSB) (connection between the CPU and the motherboard) did not, resulting in a performance bottleneck. [2]
Thomas Nicely, a professor of mathematics at Lynchburg College, had written code to enumerate primes, twin primes, prime triplets, and prime quadruplets.Nicely noticed some inconsistencies in the calculations on June 13, 1994, shortly after adding a Pentium system to his group of computers, but was unable to eliminate other factors (such as programming errors, motherboard chipsets, etc.) until ...
Using a standardized interface and protocol allows systems-management software based on IPMI to manage multiple, disparate servers. As a message-based, hardware-level interface specification, IPMI operates independently of the operating system (OS) to allow administrators to manage a system remotely in the absence of an operating system or of the system management software.