Search results
Results from the WOW.Com Content Network
arping is a software utility for discovering hosts on a computer network by sending link layer frames using Address Resolution Protocol (ARP) requests addressed to a host identified by its MAC address. [1] The utility may use ARP to resolve an IP address provided by the user.
The Address Resolution Protocol (ARP) is a communication protocol for discovering the link layer address, such as a MAC address, associated with a internet layer address, typically an IPv4 address. The protocol, part of the Internet protocol suite , was defined in 1982 by RFC 826 , which is Internet Standard STD 37.
MAC addresses need to be individually configured on the servers by an administrator. RARP is limited to serving only IP addresses . Reverse ARP differs from the Inverse Address Resolution Protocol (InARP), which is designed to obtain the IP address associated with a local Frame Relay data link connection identifier. [ 2 ]
In promiscuous mode, some software might send responses to frames even though they were addressed to another machine. However, experienced sniffers can prevent this (e.g., using carefully designed firewall settings). An example is sending a ping (ICMP echo request) with the wrong MAC address but the right IP address.
MAC addresses are primarily assigned by device manufacturers, and are therefore often referred to as the burned-in address, or as an Ethernet hardware address, hardware address, or physical address. Each address can be stored in the interface hardware, such as its read-only memory , or by a firmware mechanism.
A broadcast address is a network address used to transmit to all devices connected to a multiple-access communications network. A message sent to a broadcast address may be received by all network-attached hosts. In contrast, a multicast address is used to address a specific group of devices, and a unicast address is used to address a single ...
TCP/IP defines the addresses 192.168.4.0 (network ID address) and 192.168.4.255 (broadcast IP address). The office's hosts send packets to addresses within this range directly, by resolving the destination IP address into a MAC address with the Address Resolution Protocol (ARP) sequence and then encapsulates the IP packet into a MAC frame ...
A well-known example of this is the ping utility. [7] ICMP responses will be allowed back through the firewall. In some scenarios, UDP communication can use ICMP to provide information about the state of the session so ICMP responses related to a UDP session will also be allowed back through.