Search results
Results from the WOW.Com Content Network
The wires are wrapped two to three times around each other . The bare veins on a length of about 3 cm "strangle" or "twist". In some cases, the strangulation is soldered. To isolate the splice, an insulating sleeve made of paper or plastic is pushed over it. The splicing of copper wires is mainly used on paper insulated wires.
The 1915 textbook Practical Electric Wiring describes the construction of the Western Union splice; short tie and long tie. The short tie splice has it being formed after stripping the insulation from a pair of wires for several inches, each, crossing the wires left over right as shown in figure part A; then, a hooked cross (figure part B) is formed holding the crossing point of the two wires ...
Chain splice – Attached the working end of a rope to a chain. [7] Figure-eight "splice" knot – A splice-like bend knot used for joining two ropes. Horseshoe splice – A cut splice where the two sides of the loop are of unequal length. Long splice – A splice used to join two rope ends forming one rope the length of the total of the two ropes.
A rat-tail splice, also known as a twist splice or a pig-tail splice, is a basic electrical splice that can be done with both solid and stranded wire. It is made by taking two or more bare wires and wrapping them together symmetrically around the common axis of both wires. The bare splice can be insulated with electrical tape or by other means.
If colored white, it typically may be used for splicing neutral wires in a device box, while leaving a pigtail free for connection to a device (such as a receptacle). If colored green, the assembly is intended to be used as a grounding pigtail, similar to the feedthrough twist-on wire connectors without a permanently-attached wire.
Lineman's pliers are used in the electrical trade to cut, straighten, and bend wire, and also to twist wires together when making splices. Lineman's can be used to strip wire and some types of cable, although wire strippers are more commonly used for this purpose as they can strip wire more quickly without damaging the conductors themselves.
The eye splice is a method of creating a permanent loop (an "eye") in the end of a rope by means of rope splicing. The Flemish eye is a type of circular loop at the end of a thread. There are several techniques of creating the eye with its knot tied back to the line, rope or wire. [3] [4]
Crimped connectors fulfill numerous uses, including termination of wires to screw terminals, blade terminals, ring/spade terminals, wire splices, or various combinations of these. A tube-shaped connector with two crimps for splicing wires in-line is called a butt splice connector. Single-wire crimp terminals include: