Ads
related to: pearson 110 current probe- Automotive Reviews Blog
Read Our How-to Guides and
Automotive Blog to Learn More.
- Automotive Deals
Shop The Best Automotive.
Get Today's Best Deals.
- Automotive Reviews Blog
Search results
Results from the WOW.Com Content Network
In electrical and electronic engineering, a current clamp, also known as current probe, is an electrical device with jaws which open to allow clamping around an electrical conductor. This allows measurement of the current in a conductor without the need to make physical contact with it, or to disconnect it for insertion through the probe.
A Rogowski coil, named after Walter Rogowski, is an electrical device for measuring alternating current (AC) or high-speed current pulses. It sometimes consists of a helical coil of wire with the lead from one end returning through the centre of the coil to the other end so that both terminals are at the same end of the coil.
A test probe is a physical device used to connect electronic test equipment to a device under test (DUT). Test probes range from very simple, robust devices to complex probes that are sophisticated, expensive, and fragile. Specific types include test prods, oscilloscope probes and current probes.
In electrical engineering, current sensing is any one of several techniques used to measure electric current. The measurement of current ranges from picoamps to tens of thousands of amperes. The selection of a current sensing method depends on requirements such as magnitude, accuracy, bandwidth, robustness, cost, isolation or size. The current ...
Pearson-Anson oscillator circuit. The Pearson–Anson effect, discovered in 1922 by Stephen Oswald Pearson [1] and Horatio Saint George Anson, [2] [3] is the phenomenon of an oscillating electric voltage produced by a neon bulb connected across a capacitor, when a direct current is applied through a resistor. [4]
The main differences between RFT and conventional eddy-current testing (ECT) is in the coil-to-coil spacing. The RFT probe has widely spaced coils to pick up the through-transmission field. The typical ECT probe has coils or coil sets that create a field and measure the response within a small area, close to the object being tested.
Eddy current sensors are displacement sensors that use the principle of eddy current formation to sense displacement. These sensors measure shaft displacement in rotating machinery and have been around for many years as they offer manufacturers high-linearity, high-speed measurements, and high resolution. [ 1 ]
DCVG (direct current voltage gradient) is a survey technique used for assessing the effectiveness of corrosion protection on buried steel structures. [1] In particular, oil and natural gas pipelines are routinely monitored using this technique to help locate coating faults and highlight deficiencies in their cathodic protection (CP) strategies.
Ads
related to: pearson 110 current probe