Search results
Results from the WOW.Com Content Network
In 2010, Pratt & Whitney launched the development of an ultra high-bypass version, with a ratio significantly higher than the PW1100G's 12.2:1 for the A320neo, to improve fuel consumption by 20% compared to a CFM56-7 and reduced noise relative to the FAA's Stage 4 by 25 dB. In 2012, wind tunnel tests were completed on an earlier version of the ...
The bypass ratio (BPR) of a turbofan engine is the ratio between the mass flow rate of the bypass stream to the mass flow rate entering the core. [1] A 10:1 bypass ratio, for example, means that 10 kg of air passes through the bypass duct for every 1 kg of air passing through the core.
Turbofan engines with a bypass ratio of at least 4. Pages in category "High-bypass turbofan engines" The following 49 pages are in this category, out of 49 total.
A propfan, also called an open rotor engine, open fan engine [1] [2] or unducted fan (as opposed to a ducted fan), is a type of aircraft engine related in concept to both the turboprop and turbofan, but distinct from both.
The first (experimental) high-bypass turbofan engine was the AVCO-Lycoming PLF1A-2, a Honeywell T55 turboshaft-derived engine that was first run in February 1962. The PLF1A-2 had a 40 in diameter (100 cm) geared fan stage, produced a static thrust of 4,320 lb (1,960 kg), [ 44 ] and had a bypass ratio of 6:1. [ 45 ]
The General Electric GE36 was an experimental aircraft engine, a hybrid between a turbofan and a turboprop, known as an unducted fan (UDF) or propfan.The GE36 was developed by General Electric Aircraft Engines, [3] with its CFM International equal partner Snecma taking a 35 percent share of development. [4]
The GE Passport is a high bypass ratio turbofan. The engine is a twin-spool, axial-flow turbofan with a high bypass ratio of 5.6:1 and an overall pressure ratio of 45:1. The front fan is attached to the three-stage low-pressure compressor; the 23:1 pressure ratio 10-stage high-pressure compressor includes five blisk stages for weight reduction.
The General Electric GE9X is a high-bypass turbofan developed by GE Aerospace exclusively for the Boeing 777X. It first ran on the ground in April 2016 and first flew on March 13, 2018; it powered the 777-9's maiden flight in early 2020. It received its Federal Aviation Administration (FAA) type certificate on September 25, 2020.