Search results
Results from the WOW.Com Content Network
A grease gun (pneumatic) A grease gun is a common workshop and garage tool used for lubrication. The purpose of the grease gun is to apply lubricant through an aperture to a specific point, usually from a grease cartridge to a grease fitting or 'nipple'. The channels behind the grease nipple lead to where the lubrication is needed.
At this point, the Hole-Shooter, a drill that weighed 5 lbs. was created by A. H. Peterson. The Peterson Company eventually went bankrupt after a devastating fire and recession, but the company was auctioned off to A. F. Siebert, [21] a former partner in the Peterson Company, in 1924 and became the Milwaukee Electric Tool Company. [22]
The M3 is an American .45-caliber submachine gun adopted by the U.S. Army on 12 December 1942, as the United States Submachine Gun, Cal. .45, M3. [12] The M3 was chambered for the same .45 ACP round fired by the Thompson submachine gun , but was cheaper to mass produce and lighter, at the expense of accuracy. [ 12 ]
The most common causes are accidents with grease guns, paint sprayers, and pressure washers, but working on diesel and gasoline engine fuel injection systems as well as pinhole leaks in pressurized hydraulic lines can also cause this injury. Additionally, there is at least one known case of deliberate self-injection with a grease gun. [2]
The FMK-3 is a selective fire blowback-operated submachine gun of Argentinian origin designed by Fabricaciones Militares in 1974. Around 30,000 were produced for the Argentinian military by 1991. Around 30,000 were produced for the Argentinian military by 1991.
Wadham's Oil and Grease Company of Milwaukee was a chain of filling and service stations that operated in the early 20th century and was headquartered in Milwaukee, Wisconsin. The company's refinery was in Indiana. The company was headed by Harger W. Dodge, who assumed leadership from his father-in-law in 1916.
Lincoln patented the first lever grease gun to work with a full stroke operation called the Model 1242. This meant that a hand-held grease gun could generate up to 10,000 lbf/in² (70 MPa) of pressure. Operators of the unit could push grease into blocked or "frozen" fittings and the unit allowed for work in confined areas.
The test grease is inserted into the container and the plunger is stroked 60 times while the test apparatus and grease are maintained at a temperature of 25 °C. Once worked, the grease is placed in a penetration test apparatus. This apparatus consists of a container, a specially-configured cone and a dial indicator. The container is filled ...