enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Washer (hardware) - Wikipedia

   en.wikipedia.org/wiki/Washer_(hardware)

   [1] Rubber or fiber gaskets used in taps (or faucets, valves, and other piping connections) as seal against water leaks are sometimes referred to colloquially as washers; but, while they may look similar, washers and gaskets are usually designed for different functions and made differently.

3. Faucet aerator - Wikipedia

   en.wikipedia.org/wiki/Faucet_aerator

   Three major components of an aerator are: housing, insert and rubber washer. A faucet aerator can be classified on the basis of its flow rate and the type of water stream (aerated, non-aerated, spray) it produces. In general, standard-sized aerators are available with female (M22x1) or male threading (M24x1).

4. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   [18]: 71 The rubber sleeves are typically secured with stainless steel worm drive clamping bands, which compress the rubber to make a tight seal around the pipes and fittings. These pipe clamps are similar to hose clamps , but are heavier-duty and ideally are made completely of stainless steel (including the screw) to provide maximum service life.

5. Silicone grease - Wikipedia

   en.wikipedia.org/wiki/Silicone_grease

   As with TMS, the signal is a singlet. In 1 H NMR, silicone grease appears at a singlet at δ = 0.07 ppm in CDCl 3, 0.09 in CD 3 CN, 0.29 in C 6 D 6, and −0.06 ppm in (CD 3) 2 SO. In 13 C NMR, it appears at δ = 1.19 ppm in CDCl 3 and 1.38 ppm in C 6 D 6. Tables of impurities commonly found in NMR spectroscopy have been prepared, and such ...

6. News, Politics, Sports, Mail & Latest Headlines - AOL.com

   homepage.aol.com

   Discover the latest breaking news in the U.S. and around the world — politics, weather, entertainment, lifestyle, finance, sports and much more.

7. Tap (valve) - Wikipedia

   en.wikipedia.org/wiki/Tap_(valve)

   A fibre washer (which expands when wet, aiding the seal) is used between the connector and the tap tail. Tap tails are normally 1 ⁄ 2 " or 12 mm in diameter for sinks and 3 ⁄ 4 " or 19 mm for baths, although continental Europe sometimes uses a 3 ⁄ 8 " (still imperial) size.