Search results
Results from the WOW.Com Content Network
OBD-II PIDs (On-board diagnostics Parameter IDs) are codes used to request data from a vehicle, used as a diagnostic tool.. SAE standard J1979 defines many OBD-II PIDs. All on-road vehicles and trucks sold in North America are required to support a subset of these codes, primarily for state mandated emissions inspections.
For example, in several Mazda models, the light will come on at 80,000 miles (130,000 km) and remain lit without generating a computer trouble code. [citation needed] Volvo had a light labeled "lambda", lambda sond being another name for oxygen sensor. This was done in order to remind the driver to change the oxygen sensor.
A throttle position sensor (TPS) is a sensor used to monitor the throttle body valve position for the ECU of an engine. The sensor is usually located on the butterfly spindle/shaft, so that it can directly monitor the position of the throttle. More advanced forms of the sensor are also used.
A typical ETC system consists of three major components: (i) an accelerator pedal module (ideally with two or more independent sensors), (ii) a throttle valve that can be opened and closed by an electric motor (sometimes referred to as an electric or electronic throttle body (ETB)), and (iii) a powertrain or engine control module (PCM or ECM). [4]
If the exhaust system is hot enough to autoignite, an after-fire may result; this can be seen as a flame discharging through the exhaust system. On a fuel-injected engine, ignoring the throttle (no fuel) while starting permits electronic logic systems to produce the correct fuel mixture, often based on exhaust gases.
Electronic throttle control, throttle position sensor fault or cruise control failure (see drive by wire) [11] Stuck throttle (unrelated to pedal position) [12] [13] Shorting of tin whiskers [14] [15] Diesel engine runaway: Diesel engine power is governed by the amount of fuel supplied. Excessive pressure in the crankcase can force mist of ...
The advent of concern about fuel economy and emissions had major impacts on engine design. Some of the trade-offs reduced throttle response. Most new cars employ a drive-by-wire system, which includes electronic throttle control and can itself either reduce or increase throttle response (Depending on whether or not it's being employed on a performance car).
In fuel injected engines, the throttle body is the part of the air intake system that controls the amount of air flowing into the engine, in response to driver accelerator pedal input in the main. The throttle body is usually located between the air filter box and the intake manifold, and it is usually attached to, or near, the mass airflow sensor.