Search results
Results from the WOW.Com Content Network
A wheelset is a pair of railroad vehicle wheels mounted rigidly on an axle allowing both wheels to rotate together. Wheelsets are often mounted in a bogie (" truck " in North America ) – a pivoted frame assembly holding at least two wheelsets – at each end of the vehicle.
The small rail wheels fitted to road–rail vehicles allow them to be stowed away when the vehicle is in road-going mode. Wheels used for road–rail vehicles are normally smaller than those found on other types of rolling stock, such as locomotives or carriages, because the wheel has to be stowed clear of the ground when the vehicle is in road-going mode.
The main notations are the Whyte notation (based on counting the wheels), the AAR wheel arrangement notation (based on counting either the axles or the bogies), and the UIC classification of locomotive axle arrangements (based on counting either the axles or the bogies).
Union Pacific 844, the only steam locomotive never retired by a North American Class I railroad. The 4-8-4 wheel arrangement was a progression from the 4-8-2 Mountain type and, like the 2-8-4 Berkshire and 4-6-4 Hudson types, an example of the "Super Power" concept in steam locomotive design that made use of the larger firebox that could be supported by a four-wheel trailing truck, which ...
A bogie in the UK, or a railroad truck, wheel truck, or simply truck in North America, is a structure underneath a railway vehicle (wagon, coach or locomotive) to which axles (hence, wheels) are attached through bearings. In Indian English, bogie may also refer to an entire railway carriage. [4]
An axlebox, also known as a journal box in North America, is the mechanical subassembly on each end of the axles under a railway wagon, coach or locomotive; it contains bearings and thus transfers the wagon, coach or locomotive weight to the wheels and rails; the bearing design is typically oil-bathed plain bearings on older rolling stock, or roller bearings on newer rolling stock.
The primary reason that the original RoadRailer concept was not viable was the weight penalty imposed on the trailers because of the attached railroad wheelset. This was resolved in later designs which removed the integrated wheelset by having a dedicated rail bogie assembly that stayed in the rail yard, as seen today. [citation needed] [9]
With the permission of the Royal Railway Administration in Frankfurt a. M., wheelsets with paper discs were manufactured in the main railway workshop in Saarbrücken and in the railway car wheels factory of the van der Zypen brothers in Deutz and then put into use. Such wheelsets with paper pulp discs were in regular service on wagons for a ...