Search results
Results from the WOW.Com Content Network
This UART has 16-byte FIFO buffers. Its receive interrupt trigger levels can be set to 1, 4, 8, or 14 characters. Its maximum standard serial port speed if the operating system has a 1 millisecond interrupt latency is 128 kbit/s. Systems with lower interrupt latencies or with DMA controllers could handle higher baud rates.
A universal synchronous and asynchronous receiver-transmitter (USART, programmable communications interface or PCI) [1] is a type of a serial interface device that can be programmed to communicate asynchronously or synchronously. See universal asynchronous receiver-transmitter (UART) for a discussion of the asynchronous capabilities of these ...
For example, the UART-based FlexWire protocol begins each frame with a 'U' (0x55) sync byte. FlexWire receivers use the sync byte to precisely set their UART bit-clock frequency without a high-precision oscillator. [4] For example, the Ethernet preamble contains 56 bits of alternating 1 and 0 bits for synchronizing bit clocks.
Asynchronous serial communication is a form of serial communication in which the communicating endpoints' interfaces are not continuously synchronized by a common clock signal. Instead of a common synchronization signal, the data stream contains synchronization information in form of start and stop signals, before and after each unit of ...
The 16550 UART (universal asynchronous receiver-transmitter) is an integrated circuit designed for implementing the interface for serial communications. The corrected -A version was released in 1987 by National Semiconductor . [ 1 ]
The 8250 UART was used in several 8-bit computers at least since 1978. IBM used the 8250 UART in the IBM PC (1981). The 8250A and 8250B revisions were later released, and the 16450 was introduced with the IBM Personal Computer/AT (1984). The main difference between releases was the maximum communication speed. [4]
Parity was also used on at least some paper-tape (punched tape) data entry systems (which preceded magnetic-tape systems). On the systems sold by British company ICL (formerly ICT) the 1-inch-wide (25 mm) paper tape had 8 hole positions running across it, with the 8th being for parity. 7 positions were used for the data, e.g., 7-bit ASCII.
Modbus or MODBUS is a client/server data communications protocol in the application layer. [1] It was originally designed for use with programmable logic controllers (PLCs), [2] but has become a de facto standard communication protocol for communication between industrial electronic devices in a wide range of buses and networks.